Gain Calibration of Current-to-Voltage Converters
نویسندگان
چکیده
منابع مشابه
Design and Analysis of Current-to-Voltage and Voltage - to-Current Converters using 0.35μm technology
This paper presents the design of a Current-toVoltage (I−V) and Voltage-to-Current (V−I) converters for use in current-mode analog integrated circuits are described. The proposed I−V converter and V-I Converter has high linear range. The circuit uses MOS transistors in linear and saturation regions to produce an output current linearly related to the input voltage. Both circuits have been imple...
متن کاملWide-Dynamic-Range and High-Sensitivity Current-to-Voltage Converters
A wide dynamic range and a high sensitivity are often incompatible with each other in analog circuits, such as signal converters or amplifiers. In this paper, we present a method of developing current-to-voltage converters featuring both. It comprises two current-to-voltage conversions. One is to convert the DC component, i.e. the average level of the current input, into a voltage with a nonlin...
متن کاملA Transformerless Boost Converters with High Voltage Gain and Reduced Voltage Stresses on the Active Switches
Usually basic dc-dc boost converters are unable to provide high step up voltage gain due to the effect of power switches, rectifier diodes and equivalent series resistance of inductors and capacitors and the voltage stresses on the power switches are high. This paper proposes a simple transformerless dc-dc converters to achieve high step up voltage gain without an extremely high duty ratio. The...
متن کاملLow Power Low Voltage Current Mode Pipelined A/D Converters
This paper presents two prototypes of low power low voltage current mode 9 bit pipelined a/d converters. The first and the second converters are configured of 1.5 bit and 2.5 bit stages, respectively. The a/d converter structures are composed of current mode building blocks and final comparator block which converts the analog current signal into digital voltage signal. All building blocks have ...
متن کاملVoltage and Current Spectra for Matrix Power Converters
Matrix power converters are used for transforming one alternating-current power supply to another, with different peak voltage and frequency. There are three input lines, with sinusoidally varying voltages which are 120◦ out of phase one from another, and the output is to be delivered as a similar three-phase supply. The matrix converter switches rapidly, to connect each output line in sequence...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Research of the National Institute of Standards and Technology
سال: 2018
ISSN: 2165-7254
DOI: 10.6028/jres.123.019