Geometry Effects in Four-Point Bending Test for Thin Sheet Studied by Finite Element Simulation
نویسندگان
چکیده
منابع مشابه
Using the Finite Element Analysis Method to Study the 3-point Bending Test for the Characterization of the Adherence
An elastic finite element analysis was conducted to evaluate the stress distribution in the initiation zone of the adhesive rupture during the 3-point bending test. This test is used to measure the adherence between a polyepoxy adhesive and aluminum alloy with different surface treatments. The purpose is to compare, in the high stress concentration areas, the stress fields calculated using fini...
متن کاملCluster Analysis of Acoustic Emission Signals for Carbon/Epoxy Composite in Four-point Bending Test (RESEARCH NOTE)
Due to the extensive use of composites in various industries and the fact that defects reduce ultimate strength and efficiency during operation, detection of failures in composite parts is very important. The aim of this paper is to use Acoustic Emission (AE) non-destructive method in four-point bending test of carbon/epoxy composite to analyze and examine the failure mechanisms. This method is...
متن کاملUsing Finite Element Software to Simulation Fracture Behavior of Three-point Bending Beam with Initial Crack
using computation software to simulate fracture behaviors of structures can shorten the time to estimate safety of engineering structures and reduce a lot of cost of experiment. However three dimensional numerical simulation for fracture process is a challenging issue, because the convergence and accuracy are not easily obtained and high computational cost is generated. In this paper, three new...
متن کاملAxial Crushing Analysis of Sandwich Thin-walled Tubes using Experimental and Finite Element Simulation
Application of impact energy absorption systems in different industries is of special significance. Thin-walled tubes, due to their lightness, high energy absorption capacity, long crushing length and the high ratio of energy absorption to weight, have found ever-increasing application as one of the most effective energy absorption systems. In this research, through carrying out experimental t...
متن کاملFinite Element Simulation of Hydrostatic Extrusion Process to Produce Thin Bimetallic Parts
The hydrostatic extrusion is a new method of extrusion process. The most important advantage of this method is reduction of friction and close tolerance for the coating thickness. In this study, the hydrostatic extrusion simulation of bimetallic wires has performed using of finite element method. In the following the advantages of hydrostatic extrusion compared to the direct extrusion are prese...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2016
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.m2015178