GLASS-LIKE CARBON SPUTTERING TARGET FOR PROTECTIVE LAYER
نویسندگان
چکیده
منابع مشابه
Protective diamond-like carbon coatings for future optical storage disks
Diamond-like carbon (DLC) is a promising protective coating for future optical storage technologies. The requirements place conflicting constraints on the nature of the DLC. It must be transparent at 400 nm, hard and wear-resistant, uniform, pinhole-free, have a low stress and be deposited at high rate without a high heat load on a plastic substrate. In order to optimise the films under these c...
متن کاملExploring the potential of high power impulse magnetron sputtering for growth of diamond-like carbon films
Amorphous carbon films are deposited employing high power impulse magnetron sputtering (HiPIMS) at pulsing frequencies of 250 Hz and 1 kHz. Films are also deposited by direct current magnetron sputtering (dcMS), for reference. In both HiPIMS and dcMS cases, unipolar pulsed negative bias voltages up to 150 V are applied to the substrate to tune the energy of the positively charged ions that bomb...
متن کاملPulsed sputtering during homoepitaxial surface growth: layer-by-layer forever
The homoepitaxial growth of initially flat surfaces has so far always led to surfaces which become rougher and rougher as the number of layers increases: even in systems exhibiting ‘‘layer-by-layer’’ growth the registry of the layers is gradually lost. We propose that pulsed glancing-angle sputtering, once per monolayer, can in principle lead to layer-by-layer growth that continues indefinitely...
متن کاملNanoparticle decoration of carbon nanotubes by sputtering
Vapor phase growth of gold, nickel and titanium metal nanoparticles on multiwall carbon nanotube (MWCNT) buckypaper by sputtering was investigated. The size and distribution of nanoparticles was dependent on the intrinsic binding energy of the metal elements, but could be altered to mimic that of metals with different binding energies by in situ modification of the MWCNT surfaces by energetic m...
متن کاملNitrogen and Aluminum Doped Diamond-like Carbon Thin Films by Dc Magnetron Sputtering Deposition
Diamond-like carbon (DLC) thin films used in this study were prepared with DC magnetron sputtering deposition. Silicon (100) wafers were used as the substrates onto which an RF bias was applied during the film deposition. For the nitrogen doped DLC films, a pure graphite target was used as the carbon source and nitrogen gas was introduced into the deposition chamber via a mass flow controller. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 1989
ISSN: 0285-0192,1880-4004
DOI: 10.3379/jmsjmag.13.s1_179