Gravity Flow Mechanism of Cohesive Materials
نویسندگان
چکیده
منابع مشابه
Simulation of Gravity Flow of Granular Materials in Silos
The problem of determining the steady state flow of granular materials in silos under the action of gravity is considered. In the case of a Mohr-Coulomb material, the stress equations correspond to a system of hyperbolic conservation laws with source terms and nonlinear boundary conditions. A higher order Discontinuous Galerkin method is proposed and implemented for the numerical resolution of ...
متن کاملGravity Flow of Granular Materials in Conical Hoppers
This paper presents an approximate solution to the flow of a cohesionless granular material in a conical hopper. This is a problem which has received considerable attention in the past though much of the work was directed toward developing an empirical relation of the mass flow rate from experimental data (for example (1,211. In the early 1960's Jenike and Johanson [23] applied the basic princi...
متن کاملGravity flow instability of viscoplastic materials: the ketchup drip.
In contrast with simple liquids such as water, milk, honey, which easily flow as a continuous jet when poured from a vessel, pasty materials such as mayonnaise, mustard, ketchup, puree, etc., fall by fits and starts in a wide range of flow rates. This may, for example, be observed when ketchup or mayonnaise is pushed from a tube at a sufficient height over a plate: although surface tension effe...
متن کاملCohesive granular materials composed of nonconvex particles.
The macroscopic cohesion of granular materials made up of sticky particles depends on the particle shapes. We address this issue by performing contact dynamics simulations of 2D packings of nonconvex aggregates. We find that the macroscopic cohesion is strongly dependent on the strain and stress inhomogeneities developing inside the material. The largest cohesion is obtained for nearly homogene...
متن کاملForce Transmission Modes of Non-Cohesive and Cohesive Materials at the Critical State
This paper investigates the force transmission modes, mainly described by probability density distributions, in non-cohesive dry and cohesive wet granular materials by discrete element modeling. The critical state force transmission patterns are focused on with the contact model effect being analyzed. By shearing relatively dense and loose dry specimens to the critical state in the conventional...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Research Association of Powder Technology, Japan
سال: 1967
ISSN: 1883-8766
DOI: 10.4164/sptj1964.4.651