Hardness of electroless Ni-Co-B alloy films by ultra micro hardness tester.
نویسندگان
چکیده
منابع مشابه
Ni-B Coating Production on Magnesium Alloy by Electroless Deposition
The use of magnesium alloys is limited due to their susceptibility to corrosion although they have many attractive physical and mechanical properties. To increase mechanical and corrosion properties of these alloys, many deposition method and coating types are used. Electroless Ni–B coatings have received considerable interest recently due to its unique properties such as cost-effectiveness, th...
متن کاملA New Grain Hardness Tester
.\ hardness tester, especially adapted for grain, was cor~structecl by modifying a commercial portable soft metal tester known as the Barcol Impressor. h preloaded stylus is forced into grain sections preparetl by rneans ot a microtome. The displacement of the stylus, nleasured by a dial micrometer, is used as a hardness index. This has been related to tlie l'ickers tlianlontl pyramid hardness ...
متن کاملAnalysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...
متن کاملThe micro-hardness of enamel and dentin.
THE hardness of enamel and dentin has been determined by a variety of methods including abrasion," 2 pendulum,' scratch,4-7 and indentation" teehnics. Since the hardness of enamel and dentin has been shown to have considerable local variations, the methods using a microscratch or microindentation have been preferred. One of the more common types is the Knoop diamond indenter14 which has been us...
متن کاملNanocrystalline structure and hardness of thin films
WaSiaN films were deposited by reactive sputtering in a N2+Ar atmosphere from a W target incrusted with different number of Si pieces. The coatings present different crystallographic structures from the crystalline a-W and W2N to amorphous phase. Crystalline films have very low grain sizes from 15 down to 3 nm. For WaSi films there is a good correlation between the increase of the hardness and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surface Finishing Society of Japan
سال: 1990
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.41.700