Health management using fault detection and fault tolerant control of multicellular converter applied in more electric aircraft system
نویسندگان
چکیده
1. Rodger D. Current status and future plans for electric motors drives at NASA. IEEE International Electric Motors Drives Conference. 2021. Google Scholar
منابع مشابه
Fault Diagnosis and Fault-Tolerant SVPWM Technique of Six-phase Converter under Open-Switch Fault
In this paper, a new open-switch fault diagnosis method is proposed for the six-phase AC-DC converter based on the difference between the phase current and the corresponding reference using an adaptive threshold. The open-switch faults are detected without any additional equipment and complicated calculations, since the proposed fault detection method is integrated with the controller required ...
متن کاملDSP-Based Sensor Fault Detection and Post Fault-Tolerant Control of an InductionMotor-Based Electric Vehicle
This paper deals with sensor fault detection within a reconfigurable direct torque control of an induction motor-based electric vehicle. The proposed strategy concerns current, voltage, and speed sensors faults that are detected and followed by post faulttolerant control to allow the vehicle continuous operation. The proposed approach is validated through experiments on an induction motor drive...
متن کاملIntegrated Fault-Detection and Fault-Tolerant Control of Process Systems
The problem of implementing fault-tolerant control to nonlinear processes with input constraints subject to control actuator failures is considered, and an approach predicated upon the idea of integrating fault-detection, feedback and supervisory control is presented and demonstrated. To illustrate the main idea behind the proposed approach, availability of measurements of all the process state...
متن کاملFault Tolerant Control and Fault Detection and Isolation
When a fault occurs in a system, the main problem to be addressed is to raise an alarm, ideally diagnose what fault has occurred, and then decide how to deal with it. The problem of detecting a fault, finding the source/location and then taking appropriate action is the basis of fault tolerant control. In this chapter, an introduction to fault tolerant control (FTC) and fault detection and isol...
متن کاملFault Tolerant Control and Fault Detection and Isolation
When a fault occurs in a system, the main problem to be addressed is to raise an alarm, ideally diagnose what fault has occurred, and then decide how to deal with it. The problem of detecting a fault, finding the source/location and then taking appropriate action is the basis of fault tolerant control. In this chapter, an introduction to fault tolerant control (FTC) and fault detection and isol...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Diagnostyka
سال: 2022
ISSN: ['1641-6414', '2449-5220']
DOI: https://doi.org/10.29354/diag/151039