Heat Pump Unit Based on Principle of Stream Thermocompression Using Water-Ammonia Solution

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Screw Compressor For Ammonia-Water Heat Pump Lubricated By The Process Mixture

A prototype compressor for application in high temperature compression-resorption heat pumps has been designed, manufactured and tested. The paper presents details of the compressor design together with test results obtained on the pilot heat pump plant with the prototype compressor. The compressor is of the twin-screw type and its stainless steel rotors operate without timing gears. There is n...

متن کامل

Investigation of an Ammonia−water Based Power/cooling Cogeneration System Using Sensible Waste Heat

In this study, the problem of a parallel connected power and absorption cooling cogeneration system was analyzed and then an improved configuration based on this system was proposed. This system can make cascade utilization of the turbine exhaust heat. By varying turbine outlet pressure, different turbine exhaust vapor temperatures can be obtained, resulting in different amounts of heat that ca...

متن کامل

hazard evaluation of gas condensate stabilization and dehydration unit of parsian gas refinery using hazop procedures

شناسایی مخاطرات در واحد 400 پالایشگاه گاز پارسیان. در این پروزه با بکارگیری از تکنیک hazop به شناسا یی مخاطرات ، انحرافات ممکن و در صورت لزوم ارایه راهکارهای مناسب جهت افزایش ایمنی فرا یند پرداخته میگردد. شرایط عملیاتی مخاطره آمیز نظیر فشار و دمای بالا و وجود ترکیبات مختلف سمی و قابل انفجار در واحدهای پالایش گاز، ضرورت توجه به موارد ایمنی در این چنین واحدهایی را مشخص می سازد. مطالعه hazop یک ر...

Investigation of the Performance of a Heat Pump Using Waste Water as a Heat Source

In this research, a water-water heat pump system using waste water as a heat source, a type that is not often used in Turkey and the World, was experimentally modeled. The experiments were performed under the conditions of simulated waste water temperature values of 20 °C, 30 °C and 40 °C. Inlet and outlet water temperatures of the evaporator and condenser, water flow rates in the evaporator an...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Procedia Engineering

سال: 2012

ISSN: 1877-7058

DOI: 10.1016/j.proeng.2012.07.032