Heat Spreading Properties of CVD Diamond Coated Al Heat Sink

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Upper Heat S Ink Heat Pump Lower Heat Sink

The thermal diffusion factors observed for these systems vary considerably with concentration, and frequently show a change in sign at some concentration. New data on ethanol-toluene mixtures show that the sign and magnitude of the separation of the components in a thermal gradient are also strongly dependent on the mean temperature of the system. These observations, together with earlier ones ...

متن کامل

Experimental study of convective heat transfer coefficient of MgO nanofluid in a cylindrical microchannel heat sink

Convective heat transfer of MgO-water nanofluid in a microchannel heat sink is experimentally investigated in various concentrations of 0.01, 0.05, 0.1, and 0.6 wt%. The microchannel consisted of 48 parallel rectangular cross section channels with the height of 800 µm, width of 524 µm and length of 52 mm. A well stability duration (ca. 1 month) was resulted by a 180 min ultra-sonication of the ...

متن کامل

Research on Properties of Fluid Pressure Drop for Electric Vehicle IGBT Pin Fin Heat Sink

The Performance of electric vehicle IGPT Pin fin heat sink can be measured by the temperature field and the fluid pressure and other parameters. In order to improve the cooling effect of Pin fin heat sink, diameter, length and distance of the fin was optimized combination. The relationship between pressure drop of the water inlet, outlet and pin fin parameters was analyzed and calculated. It wa...

متن کامل

Single Point Diamond Turning of CVD coated Silicon Carbide

Scratching experiments, using diamond styli and single point diamond tools, were performed to simulate Single Point Diamond Turning (SPDT). The results of these experiments were used to determine if a ductile response is possible, and then to determine the critical depth of cut or penetration depth for the ductile to brittle transition (DBT). The depths of the scratches produced at different lo...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Korean institute of surface engineering

سال: 2015

ISSN: 1225-8024

DOI: 10.5695/jkise.2015.48.6.297