High Conversion Ratio Converter Using Half-Bridge Sub-Modules
نویسندگان
چکیده
منابع مشابه
Grid-Connected Photovoltaic Power System Using Boost-Half- Bridge Converter
This paper focuses on the power electronics used in the renewable energy systems especially in the photovoltaic applications. In recent years, interest in natural energy has grown in response to increased concern for the environment. Due to the limitations in the energy available from conventional sources, worldwide attention is being focused on renewable sources of energy. Especially, the ener...
متن کاملHigh-conversion-ratio Bidirectional Dc–dc Converter with Coupled Inductor
Abstract—In this paper, a high-conversion-ratio bidirectional dc–dc converter with coupled inductor is proposed. In the boost mode, two capacitors are parallel charged and series discharged by the coupled inductor. Thus, high step-up voltage gain can be achieved with an appropriate duty ratio. The voltage stress on the main switch is reduced by a passive clamp circuit. Therefore, the low resist...
متن کاملHigh-Conversion-Ratio Bidirectional DC-DC Converter with Ultra Capacitors
In this paper, a high-conversion-ratio bidirectional dc–dc converter with coupled inductor is proposed. In the boost mode, two capacitors are parallel charged and series discharged by the coupled inductor. Thus, high step-up voltage gain can be achieved with an appropriate duty ratio. The voltage stress on the main switch is reduced by a passive clamp circuit. Therefore, the low resistance RDS(...
متن کاملAn introduction to LLC resonant half-bridge converter
Although in existence for many years, only recently has the LLC resonant converter, in particular in its half-bridge implementation, gained in the popularity it certainly deserves. In many applications, such as flat panel TVs, 85+ ATX PCs or small form factor PCs, where the requirements on efficiency and power density of their SMPS are getting tougher and tougher, the LLC resonant half-bridge w...
متن کاملAn Interleaved Configuration of Modified KY Converter with High Conversion Ratio for Renewable Energy Applications; Design, Analysis and Implementation
In this paper, a new high efficiency, high step-up, non-isolated, interleaved DC-DC converter for renewable energy applications is presented. In the suggested topology, two modified step-up KY converters are interleaved to obtain a high conversion ratio without the use of coupled inductors. In comparison with the conventional interleaved DC-DC converters such as boost, buck-boost, SEPIC, ZETA a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering Technology and Management Sciences
سال: 2020
ISSN: 2581-4621
DOI: 10.46647/ijetms.2020.v04i05.020