High Cycle Fatigue Properties of Roll Materials.

HIGH TEMPERATURE ELASTIC PROPERTIES OF REFRACTORY MATERIALS

Abstract: A pulse-echo technique, based on ultrasonic "long-bar" mode (LBM) velocity measurements, working up to 1700°C is described. Magnetostrictive transducers and ultrasonic lines used in a 40-85 kHz frequency range are detailed. The conditions of choice of fundamental parameters (frequency, line geometry, sample size) are discussed in relation with the nature and the microstructure of ...

Influence of Operating Conditions on High-cycle Fatigue Properties of High Alloyed Steel X20

In this paper, the effect of service temperature and life on high-cycle fatigue properties of base metal, steel X20 CrMoV 12-1, has been analysed. The effect of service conditions has been analysed by testing the new material and material that was in service for 116000 hours. The investigations have included determination of permanent fatigue strength at room and operating temperature. These in...

Effect of Low Cycle Fatigue Predamage on Very High Cycle Fatigue Behavior of TC21 Titanium Alloy

The effect of low cycle fatigue (LCF) predamage on the subsequent very high cycle fatigue (VHCF) behavior is investigated in TC21 titanium alloy. LCF predamage is applied under 1.8% strain amplitude up to various fractions of the expected life and subsequent VHCF properties are determined using ultrasonic fatigue tests. Results show that 5% of predamage insignificantly affects the VHCF limit du...

Fatigue Failure and Damage Analysis of an Anti-roll Bar Subjected to Fatigue Experiments

The available fatigue theories have been examined using simple specimens subjected to bending or tension-compression loads. Therefore, the stress fields have been generally one or two dimensional. Anti-roll bar is a component belongs to the suspension system of the vehicles. In spite of having simple circular section, due to the having several curvatures, this component experiences a three-dime...

The effect of microstructure on very high cycle fatigue properties in Ti-6Al-4V