High-Frequency Modeling of Printed Spiral Coil Probes for Radio-Frequency Interference Measurement

Radio Frequency Interference

We describe the nature of the interference challenges facing radio astronomy in the next decade. These challenges will not be solved by regulation only, negotiation and mitigation will become vital. There is no silver bullet for mitigating against interference. A successful mitigation approach is most likely to be a hierarchical or progressive approach throughout the telescope and signal condit...

Measurement and Computational Modeling of Radio-Frequency Electromagnetic Power Density Around GSM Base Transceiver Station Antennas

Evaluating the power densities emitted by GSM1800 and GSM900 BTS antennas isconducted via two methods. Measurements are carried out in half a square meter grids around twoantennas. CST Microwave STUDIO software is employed to estimate the power densities in order fordetailed antenna and tower modeling and simulation of power density. Finally, measurements obtainedfrom computational and experime...

Design Modification of Rogowski Coil for Current Measurement in Low Frequency

The principle object of this paper is to offer a modified design of Rogowski coil based on its frequency response. The improvement of the integrator circuit for nullifying the phase difference between the waveforms of the measured-current and the corresponding terminal voltage is a further object of this investigation. This paper addresses an accurate, yet more efficient measuring and protect...

Radio Frequency Interference Mitigation in Radio Astronomy

Performance comparison of inkjet and thermal transfer printed passive ultra-high-frequency radio-frequency identification tags

We compare the maximum read range of passive ultra high frequency (UHF) radio frequency identification (RFID) tags that have been produced using different metal printing techniques, specifically inkjet printing and thermal transfer printing. We used the same substrate (THERMLfilm), antenna designs, and electronic circuitry in our comparison so as to isolate the effect of the metal printing. Due...