HIGH PERFORMANCE RE-TM ALLOY TARGET FOR MO DISK PRODUCTION
نویسندگان
چکیده
منابع مشابه
Irradiation Induced Localized Amorphization in Mo-Re Alloy Films
To investigate the irradiation properties of Mo-Re alloy of low Re content (atm%: 0% 8:4%), Mo-Re alloy films were irradiated by 200 keV xenon ions at the dose of 5 10 ions/cm. Different irradiation effects were observed on the samples of different Re content. While the sample of pure Mo remained the same after irradiation, obvious localized amorphization phenomenon took place in the sample wit...
متن کاملOxidation Performance of Platinum-Clad Mo-47Re Alloy
The alloy Mo-47Re has favorable mechanical properties at temperatures above 1400 C, but it undergoes severe oxidation when used in air with no protective coating. To shield the alloy from oxidation, platinum cladding has been evaluated. The unprotected alloy undergoes catastrophic oxidation under static and dynamic oxidation conditions. The platinum cladding provides good protection from static...
متن کاملMo-Si-B Alloy Development
Alloys consisting of the phases α-Mo (Mo solid solution), Mo3Si, and Mo5SiB2 (“T2”) were fabricated by ingot and powder metallurgy. A novel powder-metallurgical processing technique was developed which allows the fabrication of silicide alloys with a continuous α-Mo matrix. In these alloys the relatively ductile and tough α-Mo matrix acts as a “binder” for brittle silicide particles. An alloy p...
متن کاملUsing ParallelR TM for High Performance Monte Carlo Simulation
Virtually all enterprises are facing increasing levels of competition in the global economy that has tended to level the competitive playing field. This intensified competition drives us to create new innovative products and processes and to optimize the performance and cost of existing ones. Enterprises that depend on the web as a primary interface with their constituencies have a particularly...
متن کاملIn vitro performance assessment of new beta Ti-Mo-Nb alloy compositions.
New β-titanium based alloys with low Young's modulus are currently required for the next generation of metallic implant materials to ensure good mechanical compatibility with bone. Several of these are representatives of the ternary Ti-Mo-Nb system. The aim of this paper is to assess the in vitro biological performance of five new low modulus alloy compositions, namely Ti12Mo, Ti4Mo32Nb, Ti6Mo2...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 1993
ISSN: 1880-4004,0285-0192
DOI: 10.3379/jmsjmag.17.s1_315