High power activeX-band pulse compressor using plasma switches
نویسندگان
چکیده
منابع مشابه
APPLICATION OF PLASMA EROSION OPENING SWITCHES TO HIGH POWER ACCELERATORS FOR PULSE COMPRESSION AND POWER MULTIPLICATIONt
There has been considerable interest in recent years in using inductive storage techniques for pulsed power applications. Some of the advantages that inductive generators have over the more conventional capacitive systems include higher final stage energy density for higher power and smaller generators, lower insulator stress, faster pulse risetime, and the possibility of shorter pulse length. ...
متن کاملBroad-Band High-Power Amplifier Using Spatial Power-Combining Technique
High power, broad bandwidth, high linearity, and low noise are among the most important features in amplifier design. The broad-band spatial power-combining technique addresses all these issues by combining the output power of a large quantity of microwave monolithic integrated circuit (MMIC) amplifiers in a broad-band coaxial waveguide environment, while maintaining good linearity and improvin...
متن کاملLow Power High Speed 3-2 Compressor
This paper describes a new design of low power 3-2 compressor circuit for high speed multipliers. Power consumption of proposed 3-2 compressor circuit varies from 0.355 nW to 1.6964 nW and delay varies from 2.0390 ns to 2.0224 ns. Further, power delay product of proposed circuit varies from 7.23×10 -18 (J) to 34.30×10 -18 (J) with varying supply voltage from 1.8V to 3.3V. The proposed compresso...
متن کاملPower-handling Capability of W-band Ingaas Pin Diode Switches
One of the most active research areas in the field of radar applications is the development of collisionavoidance systems (CAS) for automotive industry. The first prototypes of HEMT-based CAS chipsets operating at 77GHz have been recently demonstrated [1]. Such chipsets will greatly benefit from the addition of a monolithic transceiver switch, which would allow using a single antenna for both t...
متن کاملDesign of a low power high speed 4-2 compressor using CNTFET 32nm technology for parallel multipliers
In this article a low power and low latency 4-2 compressor has been presented. By using modified truth table and Pass Transistor Logic (PTL) a novel structure has been proposed which outperforms previous designs from the frequency of operation view point. The proposed design method has reduced the total transistor count considerably which will lead to reduced power consumption and smaller activ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review Special Topics - Accelerators and Beams
سال: 2009
ISSN: 1098-4402
DOI: 10.1103/physrevstab.12.062003