High Speed End Milling of Hardened Steel (1st Report)
نویسندگان
چکیده
منابع مشابه
Prediction of Tool Life in End Milling of Hardened Steel AISI D2
Most published research works on the development of tool life model in machining of hardened steels have been mainly concerned with the turning process, whilst the milling process has received little attention due to the complexity of the process. Thus, the aim of present study is to develope a tool life model in end milling of hardened steel AISI D2 using PVD TiAlN coated carbide cutting tool....
متن کاملCopper Precipitation Hardened, High Strength, Weldable Steel
Steel containing 0.03% carbon, 1.35% copper and 0.84% nickel had yield strength in the 540-625 MPa (78-90 Ksi) range depending on thickness, ultimate tensile strength in the 625-690 MPa (90100 Ksi) range, and 25-30% elongation when air cooled after hot rolling. No brittle heat-affected zone was formed during manual or automatic submerged arc welding without pre-heating or postheating. The fract...
متن کاملExperimental research of chip formation mechanism during high speed machining of hardened steel
The development of chip morphology, critical cutting conditions of serrated chip formation and cutting forces were observed and measured by high speed machining experiment for 30CrNi3MoV hardened steel. Results show that the cutting speed and rake angle are leading factors to influence chip morphology and cutting forces. With the increase of cutting speed, the continuous band chip transforms in...
متن کاملProcess Design Method of High Speed and Stable Cutting Hardened Steel
In view of the unstable cutting problem in the process of high speed milling hardened steel. Conduct experiment of the stability of machine tool and high speed milling cutter. The machine tool spindle vibration spectrum and vibration acceleration signal under the condition of different centrifugal force were detected. Obtained the critical speed of security and stability cutting of milling cutt...
متن کاملGlobal Dynamics of Low Immersion High-speed Milling. Global Dynamics of Low Immersion High-speed Milling
In the case of low immersion high-speed milling, the ratio of time spent cutting to not cutting can be considered as a small parameter. In this case the classical regenerative vibration model of machine tool vibrations reduces to a simpli ed discrete mathematical model. The corresponding stability charts contain stability boundaries related to period doubling and Neimark-Sacker bifurcations. Th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1996
ISSN: 0912-0289,1882-675X
DOI: 10.2493/jjspe.62.115