High temperature creep behaviour of Al-rich Ti-Al alloys
نویسندگان
چکیده
منابع مشابه
Reviewing the class of Al-rich Ti-Al alloys: modeling high temperature plastic anisotropy and asymmetry
In the last decades, the class of Ti-rich TiAl-based intermetallic materials has replaced many contemporary alloys till 900 °C. Due to higher oxidation resistance, 20% lower density and higher (about 150 °C more) operating temperature possibility of Al-rich TiAl alloys over Ti-rich side, phases from the Al-rich region of this alloy system are considered to be highly potential candidates for hig...
متن کاملMechanical Alloys in The Al-rich Part of the Al-Ti Binary System
Aluminum is commonly used as fuel additive for propellants, incendiaries, and explosives. The main limitation to its use lies in comparatively slow ignition and oxidation/combustion kinetics. Performance can be significantly improved if pure aluminum is substituted by thermodynamically less stable alloys. In this context, mechanical alloys in the aluminum-rich section of the Al-Ti binary system...
متن کاملDIFFICULTIES IN GRAIN REFINING ALUMINUM LITHIUM ALLOYS USING COMMERCIAL Al-Ti AND Al-Ti-Bor MASTER ALLOYS
High strength aluminum alloys, especially those containing zirconium, are historically difficult to grain refine. Early efforts by Alcoa indicated that the addition of lithium to these alloys increases difficulty with grain refinement. Although grain refining of alloys 2090 and 2091 was possible, consistent results were not obtained. Statistically-designed experiments were used to quickly ident...
متن کاملCreep Behavior of Al-Si Die-Cast Alloys
Commercial, aluminum die-cast alloys are subject to long-term stresses leading to viscoelastic material responses resulting in inefficient engine operation and failure. Constant load creep tests were conducted on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys. Rupture occurred in the primary creep regime, with the eutectic alloy having the longest times to failure. Pr...
متن کاملPartitioning of solutes in multiphase Ti–Al alloys
First-principles calculations based on a plane-wave pseudopotential method, as implemented in the VASP code, are presented for the formation energies of several transition-metal and non-transition-metal dopants in Ti–Al alloys. Substitution for either Ti or Al in g-TiAl, a2-Ti3Al, Ti2AlC, and Ti3AlC are considered. Calculated szero-temperatured defect formation energies exhibit clear trends as ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2010
ISSN: 1742-6596
DOI: 10.1088/1742-6596/240/1/012084