High temperature creep characteristics of Al-6.3at%Mg alloys containing small additional elements
نویسندگان
چکیده
منابع مشابه
High Temperature Erosion- Oxidation Behavior of Nickel- Based Alloys Containing Mo in Fluidized Bed Waste Incineration
High-temperature erosion-oxidation behavior of nickel-based alloys containing 0-7 wt.% Mo in fluidized bed waste incineration conditions was studied. A stream of hot condensed air with a flow rate of 25 L/min caused hot silica sand (700 °C) mixed with 0.5 wt.% of chloride salts to hit the specimens for 250 h. By removing the erosive factor, the high-temperature oxidation behavior of the alloys ...
متن کاملCreep Behavior of Al-Si Die-Cast Alloys
Commercial, aluminum die-cast alloys are subject to long-term stresses leading to viscoelastic material responses resulting in inefficient engine operation and failure. Constant load creep tests were conducted on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys. Rupture occurred in the primary creep regime, with the eutectic alloy having the longest times to failure. Pr...
متن کاملCREEP AGE FORMING OF Al-Zn-Mg ALLOYS WITH OPTIMIZATION OF MECHANICALl PROPERTIES
Creep age forming (CAF) is one of the novel methods in aerospace industry that has been used to manufacture components of panels with improved mechanical properties and reduced fabrication cost. CAF is a combined age-hardening and stress-relaxation that are responsible for strengthening and forming, respectively. This paper deals with the experimental investigations of mechanical and springback...
متن کاملReviewing the class of Al-rich Ti-Al alloys: modeling high temperature plastic anisotropy and asymmetry
In the last decades, the class of Ti-rich TiAl-based intermetallic materials has replaced many contemporary alloys till 900 °C. Due to higher oxidation resistance, 20% lower density and higher (about 150 °C more) operating temperature possibility of Al-rich TiAl alloys over Ti-rich side, phases from the Al-rich region of this alloy system are considered to be highly potential candidates for hig...
متن کاملSmall Creep Deformations and Residual Stress Relaxation in Welded and Shot Peened Al Mg Si Cu-aluminum Alloys
The stability of compressive residual stresses and the stability of strain hardening states are seen to have high technical importance. For a laser beam welded AlMgSiCu-alloy, results of applied stress and residual stress relaxation at elevated temperatures 100<T<150°C are presented. These experiments prove the existence of back stresses. The level of these stresses can be estimated to be in th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1970
ISSN: 0451-5994
DOI: 10.2464/jilm.20.176