High‐Efficiency PbS Quantum‐Dot Solar Cells with Greatly Simplified Fabrication Processing via “Solvent‐Curing”
نویسندگان
چکیده
منابع مشابه
Solid‐State Ligand‐Exchange Fabrication of CH3NH3PbI3 Capped PbS Quantum Dot Solar Cells
CH3NH3PbI3 capped PbS colloidal quantum dots have been successfully fabricated by solid-state ligand exchange from oleate and oleylamine capped PbS. The optimal solar cells made by layer-by-layer solution deposition give a high power conversion efficiency of 4.25% with an impressive short-circuit photocurrent density of 24.83 mA cm-2.
متن کاملHybridizing ZnO Nanowires with Micropyramid Silicon Wafers as Superhydrophobic HighEfficiency Solar Cells
Low conversion efficiency is still the main limiting factor for current solar-cell technologies. A large portion of the energy loss during solar-cell operation is attributed to optical loss, namely the loss of the incoming light by reflection.[1] To reduce the reflection loss, surface texturing and antireflection coatings are the most-commonly used strategies.[2–4] Surface texturing is able to ...
متن کاملEnhanced performance of PbS-sensitized solar cells via controlled successive ionic-layer adsorption and reaction.
Despite the potential of PbS quantum dots (QDs) as sensitizers for quantum-dot-sensitized solar cells (QDSSCs), achieving a high photocurrent density over 30 mA cm(-2) remains a challenging task in PbS-sensitized solar cells. In contrast to previous attempts, where Hg(2+)-doping or multi-step post-treatment is necessary, we are capable of achieving a high photocurrent exceeding 30 mA cm(-2) sim...
متن کاملReduced Carrier Recombination in PbS - CuInS2 Quantum Dot Solar Cells
Energy loss due to carrier recombination is among the major factors limiting the performance of TiO2/PbS colloidal quantum dot (QD) heterojunction solar cells. In this work, enhanced photocurrent is achieved by incorporating another type of hole-transporting QDs, Zn-doped CuInS2 (Zn-CIS) QDs into the PbS QD matrix. Binary QD solar cells exhibit a reduced charge recombination associated with the...
متن کاملFabrication Of Cu(In,Ga)Se2 Solar Cells With In2S3 Buffer Layer By Two Stage Process
Cu(In,Ga)Se2 thin films (CIGS) on metallic substrate (titanium, molybdenum, aluminum, stainless steel) were prepared by a two-step selenization of Co-evaporated metallic precursors in Se-containing environment under N2 gas flow. Structural properties of prepared thin film were studied. To characterize the optical quality and intrinsic defect nature low-temperature photoluminescence, were perfor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Materials
سال: 2018
ISSN: 0935-9648,1521-4095
DOI: 10.1002/adma.201707572