Hot Cracking in Weld Zone.
نویسندگان
چکیده
منابع مشابه
Evaluation of metal weld-zone by using Poisson’s ratio distribution
Poisson’s ratio has not received much attention because of its narrow range of measured values and difficulties in measurement. In previous work, genuine non-destructive evaluation method of characterizing weld-zone using Poisson’s ratio distribution was proposed. The method was to use immersion ultrasonic testing for measuring longitudinal and transverse wave speeds simultaneously. In present ...
متن کاملNeurofuzzy model-based predictive control of weld fusion zone geometry
A closed-loop system is developed to control the weld fusion which is specified by the topside and back-side bead widths of the weld pool. Because in many applications only a top-side sensor is allowed which is attached to and moves with the welding torch, an image processing algorithm and neurofuzzy model have been incorporated to measure and estimate the top-side and back-side bead widths bas...
متن کاملEffect of Welding Parameters on Hot Cracking Susceptibility
The varestraint cracking test was carried out to assess the hot cracking tendency of alloy 800 at different welding conditions and augmented strain levels. The test results revealed that the hot cracking susceptibility of alloy 800 increases with increasing the heat input and augmented strain levels. This emphasizes the role of constraint either internally induced or externally applied to the w...
متن کاملEffect of Nonmetallic Inclusions on Steel Welds Metal Hot Cracking
B. Z orc, W elding I nstitute, L jubljana, S lovenia; M . I mamović, Un iversity of Zenica, Faculty of Mechanical Engineering, Zenica, B a nd H; A. Nagode, B. Kosec, L. Kosec, University of Ljubljana, Faculty of Natural Sciences and Engineering, Ljubljana, Slovenia; A. Stoić, I. Samardžić, University of Osijek, Mechanical Engineering Faculty, Slavonski Brod, Croatia Intercrystally distributed n...
متن کاملHot cracking in tungsten inert gas welding of magnesium alloy AZ91D
Plates of 3–5 mm in thickness were extracted from an AZ91D ingot and then butt joints of the plates were produced using tungsten inert gas (TIG) welding method. The TIG arc was also used to deposit welding beads on some of the thin plates. No cracking was found in the butt joints. However, hot cracking was always observed to propagate from the heat affected zone (HAZ) under the welding bead int...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 2002
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.71.455