Hot tearing susceptibility of binary Mg–Y alloy castings
نویسندگان
چکیده
منابع مشابه
Feeding of High-Nickel Alloy Castings
Feeding of the nickel-based alloys CZ-100, M-35-1, and CW-12MW, as well as of the austenitic stainless steel CN-7M, is investigated, using a combination of casting experiments and simulation. Casting trials are performed at five foundries, to produce a total of 55 plates of varying lengths and radiographic soundness levels. In order to develop the property databases necessary to simulate the ca...
متن کاملPorosity Prediction in Aluminum A356 Alloy Castings
A comprehensive methodology that takes into account alloy solidification, shrinkage-driven interdendritic fluid flow, hydrogen precipitation, and porosity evolution has been developed for the prediction of microporosity fraction in aluminum A356 alloy castings. The mathematical models presented are implemented in a computational framework consistent with those of commercial casting codes, allow...
متن کاملModeling of Stress, Distortion, and Hot Tearing
COMPUTATIONALMODELING of mechanical behavior during solidification is becoming more important. Thermal and microstructural simulations alone are insufficient to predict the quality of the final product that is desired by the casting industry. Accurate calculation of displacements, strains, and stresses during the casting process is needed to predict residual stress and distortion and defects su...
متن کاملSome Mechanical Properties of DTD 5025 Magnesium Alloy Castings 4 ’
SUMMARY This Report describes an investigation into the tensile and torsional properties of DTD 5025 magnesium alloy castings. Strength and stiffness values are given, and the variation of these parameters between different batches and manufacturers is shown. The effect on mechanical properties of long and short term temperature environments is mdwated.
متن کاملFatigue properties of Ni-43.5%Ti superelastic alloy castings.
To evaluate a Ni-43.5wt%Ti alloy as a new alloy for cast clasp, the fatigue properties of its castings were examined and compared with those of Co-Cr and Type IV Au alloys castings. The Ni-Ti alloy was cast into a phosphate-bonded investment mold using an argon-arc melting and pressure casting machine. The Ni-Ti alloy castings showed superelasticity in bending tests. Fatigue tests were carried ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials & Design
سال: 2013
ISSN: 0261-3069
DOI: 10.1016/j.matdes.2012.12.044