HoT Turning Operation in Finite Element Analysis
نویسندگان
چکیده
منابع مشابه
Correcting the stress-strain curve in hot compression test using finite element analysis and Taguchi method
In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...
متن کاملOptimizing turning operation of St37 steel using grey relational analysis
Nowadays, in order to reach minimum production cost in machining operations, various optimization methods have been proposed. Since turning operation has different parameters affecting the workpiece quality, it was selected as a complicated manufacturing method in this paper. To reach sufficient quality, all influencing parameters such as cutting speed, federate, depth of cut and tool rake angl...
متن کاملcorrecting the stress-strain curve in hot compression test using finite element analysis and taguchi method
in the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. in this study, a series of compression tests were simulated using abaqus software. in this study, it has been employed the taguchi method to design experiments by the factor...
متن کاملA Proposed Modeling Method in Finite Element Slope Stability Analysis
Limit-equilibrium method (LEM) and finite element method (FEM) with strength reduction method (SRM) techniques are the most widely used analysis tools in slope stability assessment. Recently, researchers have reported that both factor of safety (FOS) values and failure surfaces obtained from LEM and FEM are generally in good agreement, except in some particular cases. In this paper, the FOS and...
متن کاملAnalysis of Roll Wear in Reshaping Using Finite Element Simulation
Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Scientific Research in Science, Engineering and Technology
سال: 2020
ISSN: 2394-4099,2395-1990
DOI: 10.32628/ijsrset20713