Hot Workability and Dynamic Recrystallization Behaviors of Medium-Carbon Cr-Mo Alloys for High Strength Cold Heading Quality Wire Rod

Dynamic Recrystallization and Hot Workability of 316LN Stainless Steel

Chaoyang Sun 1,*, Yu Xiang 1, Qingjun Zhou 2, Denis J. Politis 3, Zhihui Sun 1,* and Mengqi Wang 1 1 School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China; [email protected] (Y.X.); [email protected] (M.W.) 2 Capital Aerospace Machinery Company, Beijing 100076, China; [email protected] 3 Department of Mechanical Engineering, Imperial Co...

Determining the Hot Deformation Temperature Range of Medium Carbon Ni-Cr-Mo Low Alloy Steels using Hot Tensile and Hot Torsion Tests

The aim of this study was to investigate the suitable temperature range for hot deformation of three medium carbon Ni-Cr-Mo low alloy steels by hot tensile and hot torsion tests. Hot tensile tests were carried out in the te,prature range of 850-1150°C at a constant strain rate of 0.1 s-1 until fracture. Then, the tensile flow behavior, hot ductility and microstructural evolution of the steels w...

Deformation and Recrystallization Behaviors in Magnesium Alloys

Recrystallization and Grain Growth of Cold drawn Gold bonding Wire

Recrystallization and grain growth of gold bonding wire have been investigated with Electron Back Scatter Diffraction (EBSD). The bonding wires were wire-drawn to an equivalent strain greater than 11.4 with final diameter between 25 and 30μm. Annealing treatments were carried out in a salt bath at 300°C, 400°C for 1 min, 10 min, 60 min, and 1 day. The textures of the drawn gold wires contain ma...

PREDICTION OF CRITICAL STRESS AND STRAIN FOR THE ONSET OF DYNAMIC RECRYSTALLIZATION IN PLAIN CARBON STEELS

The aim of the present study is the prediction of critical conditions (including critical strain and flow stress) for the initiation of dynamic recrystallization during thermo-mechanical processing of plain carbon steels. For this propose, torsion tests were conducted at different temperature (1050, 1100 and 1150˚C) and strain rates (0.002, 0.02 and 0.2/s). All flow curves showed a peak st...