Hybrid Analytical Model Coupling Laplace’s Equation and Reluctance Network for Electrical Machines
نویسندگان
چکیده
منابع مشابه
Moditication Factor for Sizing Equation of Electrical Machines-Single and Three Phase Induction Motors(RESEARCH NOTE)
Comparison between the results from the design procedure based upon the value of D2L (volume of iron) and IEC standard used by manufacturers indicates that the basic design equation of electrical machines must be modified by a proper modification factor. This modification factor is evaluated for single- and three-phase induction motors and its variation with motor rating and poles number is obt...
متن کاملNumerical and Analytical Modeling of Switched Reluctance Machines
Switched reluctance motor (SRM) has many specific advantages and has being gradually used in many kinds of applications. However, because it’s inherently multivariable, strong coupling and highly nonlinear, there are lots of difficulties to build its model. In this paper, the basic operating principle of SRM are briefly introduced firstly, and then numerical and analytical modeling methods are ...
متن کاملVoltage control of switched reluctance machines for Hybrid Electric Vehicles
The rugged low-cost construction and constant power profile of a switched reluctance motor (SRM) make it suitable for hybrid electric vehicles (HEVs). This paper describes the development of a voltage-based control strategy for a SRM. The controller design is influenced by project constraints and goals as well as the use of a new power topology. A prototype SRM and controller were built and ful...
متن کاملHybrid model in network DEA
Traditional DEA models deal with measurements of relative eciency ofDMUs regarding multiple - inputs VS. multiple-outputs. One of the drawbacksof these model is the neglect of intermediate products or linkong activities. Af-ter pointing out needs for inclusion of them to DEA models. We propose hybridmodel that can deal with intermediate products formally using this model wecan evaluate division...
متن کاملModel Order Reduction for Rotating Electrical Machines
The simulation of electric rotating machines is both computationally expensive and memory intensive. To overcome these costs, model order reduction techniques can be applied. The focus of this contribution is especially on machines that contain non-symmetric components. These are usually introduced during the mass production process and are modeled by small perturbations in the geometry (e.g., ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Magnetics
سال: 2017
ISSN: 0018-9464,1941-0069
DOI: 10.1109/tmag.2017.2654966