HYDRAULIC PERFORMANCE OF SYPHONS UNDER CONTROLL BY INLET AND OUTLET PIPE CUTTING ANGLES
نویسندگان
چکیده
منابع مشابه
Experimental and Numerical Investigation of Bottom Outlet Hydraulic Model
Using experimental models along with conducting numerical analysis have been widely used in performance recognition and optimization of hydraulic equipments. Numerical modeling has lower cost rather than experimental one; however practical tests are commonly used because of the hydraulic structure importance especially in dams. Meanwhile numerical methods could be used for future designs throug...
متن کاملThe optimization of inlet and outlet port locations of a vented square cavity
In this study, mixed convection heat transfer and local and global entropy generation in aventilated square cavity have been investigated numerically. The natural convection effect isachieved by a constant heat flux imposed at the bottom wall and cooled by injecting a coldfollow. In order to investigate the effect of port location, four different placementconfigurations of the inlet and outlet ...
متن کاملNumerical Study of a Pipe Extension Effect in Draft Tube on Hydraulic Turbine Performance
Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...
متن کاملInlet and outlet devices for rotary blood pumps.
The purposes of inlet and outlet devices for rotary blood pumps, including inducers and diffusers for axial pumps, inlet and exit volutes for centrifugal pumps, and inlet and outlet cannulas, are to guide the blood into the impeller, where the blood is accelerated, and to convert the high kinetic energy into pressure after the impeller discharge, respectively. The designs of the inlet and outle...
متن کاملAnalyses of Drill Flute and Cutting Angles
The analysis of drill cutting angles is important for the design of high-performance drill geometry. The cutting angles along the cutting edge of a drill are determined by the combination of its flute and flank surfaces. This paper examines the analysis of both flute and flank surface models and the evaluation of drill cutting angles. A new mathematical model for an arbitrary drill flute face i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Egyptian Journal for Engineering Sciences and Technology
سال: 2014
ISSN: 2682-3640
DOI: 10.21608/eijest.2014.97098