Hydrobromic acid electrolysis using a solid polymer electrolyte electrolyzer.
نویسندگان
چکیده
منابع مشابه
Polymer Electrolyte Membranes for Water Photo-Electrolysis
Water-fed photo-electrolysis cells equipped with perfluorosulfonic acid (Nafion® 115) and quaternary ammonium-based (Fumatech® FAA3) ion exchange membranes as separator for hydrogen and oxygen evolution reactions were investigated. Protonic or anionic ionomer dispersions were deposited on the electrodes to extend the interface with the electrolyte. The photo-anode consisted of a large band-gap ...
متن کاملSolid polymer electrolyte membranes for fuel cell applications—a review
Fuel cells represent a clean alternative to current technologies for utilizing hydrocarbon fuel resources. Polymer electrolyte membrane fuel cells (PEMFCs) have acquired due importance as they are best suited for applications where a quick start up is required such as in automobiles. The prime requirements of fuel cell membranes are high proton conductivity, low methanol/water permeability, goo...
متن کامل2D thermal modeling of a solid oxide electrolyzer cell (SOEC) for syngas production by H2O/CO2 co-electrolysis
Solid oxide fuel cells (SOFCs) can be operated in a reversed mode as electrolyzer cells for electrolysis of H2O and CO2. In this paper, a 2D thermal model is developed to study the heat/mass transfer and chemical/electrochemical reactions in a solid oxide electrolyzer cell (SOEC) for H2O/CO2 co-electrolysis. The model is based on 3 sub-models: a computational fluid dynamics (CFD) model describi...
متن کاملPolystyrene-Al2O3 composite solid polymer electrolyte for lithium secondary battery
In a common salt-in-polymer electrolyte, a polymer which has polar groups in the molecular chain is necessary because the polar groups dissolve lithium salt and coordinate cations. Based on the above point of view, polystyrene [PS] that has nonpolar groups is not suitable for the polymer matrix. However, in this PS-based composite polymer-in-salt system, the transport of cations is not by segme...
متن کاملStudy of MG49-PMMA Based Solid Polymer Electrolyte
The studies of rubber-polymer blends as solid polymer electrolyte for electrochemical devices application have been investigated. The electrolyte films were prepared by solution casting technique. The effect of poly(methyl methacrylate) (PMMA) and lithium tetrafluoroborate (LiBF4), salt concentration on chemical interaction, ionic conductivity, structure and morphology of 49% poly(methyl methac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON KAGAKU KAISHI
سال: 1988
ISSN: 2185-0925,0369-4577
DOI: 10.1246/nikkashi.1988.1419