Hydrostatic buoyancy correction and calibration points interpolation using tare weights

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Camera Calibration Using Vanishing Points

This paper describes a methodformeasuringthe intrinsicparameters of a camera. If aspect ratio is already known, the method requires two images of a plane; if aspect ratio is not known, the method requires three images of the plane. (Equivalently, one image of n planes could be used instead ofn images of one plane). The plane must be marked with four points in known configuration.

متن کامل

On Multivariate Interpolation by Weights

The aim of this paper is to study a particular bivariate interpolation problem, named interpolation by weights. A minimal interpolation space is derived for these interpolation conditions. An integral formula for the remainder is given, as well as a superior bound for it. An expression for g(D)(Ln(f)) is obtained.

متن کامل

Zero Weights in Weak Efficient and Inefficient Points with AHP

In this paper an approach in data envelopment analysis dealing with evaluation of non – zero slacks was propounded. This approach intends that weight of inefficient and weak efficient points that have been evaluated as zero weight, be considered as positive weight, and also in this approach, the pareto efficiency evaluates the picture of this point. In this approach positive weights in the i...

متن کامل

Active Intrinsic Calibration Using Vanishing Points

Konstantinos Daniilidis and J org Ernst Computer Science Institute, Kiel University Abstract During a camera motion with arbitrary translation and xed axis rotation a vanishing point traverses a conic section on the image plane. The intrinsic parameters of the camera can be obtained from the coe cients of the conic. Special care is given to the propagation of the error covariances and the elim...

متن کامل

Autonomous Calibration of Robots Using Planar Points

This paper presents two methods for the calibration of the geometric parameters of serial robots. They are based on putting the terminal point of the robot in a plane, only the position sensors of the joints are required. The methods can be put in practice quickly and precisely. Some practical issues concerning their practical use are given.

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Physics: Conference Series

سال: 2021

ISSN: 1742-6588,1742-6596

DOI: 10.1088/1742-6596/1826/1/012076