<i>K</i>-band CMOS LNA with interference-rejection using <i>Q</i>-enhanced notch filter
نویسندگان
چکیده
منابع مشابه
Design of UWB Filter with Notch Band for WLAN (5.3-5.8 GHz) Signal Interference Rejection
In this letter, a design of Compact Ultra-Wideband (UWB) bandpass filter with a switchable notch band for WLAN (5.3-5.9GHz) interference rejection is proposed. As 5.3-5.9GHz wireless local area network (WLAN) is existed in UWB spectrum range (3.1 -10.6GHz) and may interfere with UWB system operation. The UWB bandpass filter is implemented using a basic multiple mode resonator (MMR) structure fe...
متن کاملCMOS LNA for full UWB band
This paper presents a low voltage 2.8–11.2GHz CMOS broadband low noise amplifier (LNA) using folded common-gate (CG) topology. The broadband input matching is achieved by adopting CG topology. Bandwidth extension is proposed by inserting an inductor to create a broadband band-pass characteristic with a choke inductor. A folded topology is employed to reduce the supply voltage and thus power con...
متن کاملUWB Band Pass Filter with WLAN notch
In this paper, UWB technology operating in broad frequency range of 3.1-10.6 GHz has shown great achievement for highspeed wireless communications. to satisfy the UWB system requirements, a band pass filter with a broad pass band width, low insertion loss, and high stop-band suppression. UWB band-pass filter (BPF) with wireless local area network (WLAN) notch at 5.8 GHz and 3-dB fractional band...
متن کاملNarrow-band interference suppression in direct sequence spread spectrum systems using a lattice IIR notch filter
This paper proposes an algorithm for the suppression of narrow-band interference in direct sequence spread spectrum (DSSS) systems, based on the open loop adaptive IIR notch filtering. The center frequency of the interference is monitored on-line by the adaptive lattice IIR notch filter in [6] or by time-frequency analysis in [3]. The power of the interference signal is also estimated from the ...
متن کاملFully-integrated DECT/Bluetooth multi-band LNA in 0.18µm CMOS
The design of a multi-band low noise amplifier (LNA) is the first obstacle towards the design of a multi-standard receiver. In this paper, an approach for the design of a multi-band LNA for DECT and Bluetooth is presented. The formula for a minimal noise factor of a LNA, that takes into account the finite quality factor of the inductors is derived and the full design procedure that facilitates ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2012
ISSN: 1349-2543
DOI: 10.1587/elex.9.938