Implementation and extension of a GNU-Radio RFID reader
نویسندگان
چکیده
منابع مشابه
Implementation and extension of a GNU-Radio RFID reader
The development of a flexible software defined RFID is discused. Commercial reader systems only allow a top level view on the communication and restrict the variation for many transmission parameters. Recently a software reader from the CGran project was proposed which uses the GNU Radio environment in combination with an USRP front end. Because most of the signal processing is done on a common...
متن کاملA LTE Receiver Framework Implementation in GNU Radio
We present an open source LTE receiver framework. Using GNU Radio‘s block-based signal processing capabilities, various LTE baseband specific functionality has been implemented in dedicated easily reconfigurable blocks. These can be used to decode and analyze arbitrary channels in the LTE downlink signal. As an example we decode the Master Information Block (MIB) transmitted on the Broadcast Ch...
متن کاملA Constant Envelope OFDM Implementation on GNU Radio
Public reporting burden for this collection of information is estimated to average 1 hour per response, including the time for reviewing instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing this collection of information. Send comments regarding this burden estimate or any other aspect of this collection of information, including...
متن کاملUHF RFID Reader Antenna
This chapter addresses the various design issues, requirements, and specifications in designing reader antennas for UHF RFID applications. In a typical UHF system, the RFID reader antennas are geography specific; that is, there are different antennas for different geography, namely North America, Europe, et cetera. The discussion on the design challenges and performance expectations lead to a n...
متن کاملA GNU Radio-based IEEE 802.15.4 Testbed
We present a Software Defined Radio (SDR) based IEEE 802.15.4 transceiver testbed for GNU Radio. Our testbed is Open Source and fully interoperable with off-the-shelf TelosB sensor motes and the Contiki sensor mote operating system, from the physical layer to the network stack. The testbed can be setup and configured easily via a graphical user interface and applications can interface with the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Radio Science
سال: 2013
ISSN: 1684-9973
DOI: 10.5194/ars-11-107-2013