Improved Chuck Table Design for Silicon Wafer Defects Resolution
نویسندگان
چکیده
منابع مشابه
Hydrophobic silicon wafer bonding
Wafers prepared by an HF dip without a subsequent water rinse were bonded at room temperature and annealed at temperatures up to 1100 “C. Based on substantial differences between bonded hydrophilic and hydrophobic Si wafer pairs in the changes of the interface energy with respect to temperature, secondary ion mass spectrometry (SIMS) and transmission electron microscopy (TEM), we suggest that h...
متن کاملRemote Laboratory for Inspection of Silicon Wafer
During the last decade, there has been a significant increase in the use of remote laboratories (RL) in engineering education. These laboratories allow students to remotely access and perform measurements on real laboratory equipment via the internet. RLs are becoming common educational tools in mechanical, electrical and computer engineering departments of tertiary institutions. However, the m...
متن کاملLecture 21: Silicon wafer manufacturing
The first step in integrated circuit (IC) fabrication is preparing the high purity single crystal Si wafer. This is the starting input to the fab. Typically, Si wafer refers to a single crystal of Si with a specific orientation, dopant type, and resistivity (determined by dopant concentration). Typically, Si (100) or Si (111) wafers are used. The numbers (100) and (111) refers to the orientatio...
متن کاملAtomic-Resolution Investigation of Irradiation-Induced Defects in Silicon Carbide
Silicon carbide (SiC) possesses excellent radiation tolerance, thus, SiC and its composites are promising materials for current and future nuclear systems [1]. However, the atomistic processes that underlie the irradiation response are not sufficiently understood, due largely to the limited spatial resolution of conventional analytical tools. Comparing aberration-corrected scanning transmission...
متن کاملOptical Measurement of Cop Defects on Silicon Wafer Surface by Laser Scattered Defect Pattern
This paper presents new optical measurement method for evaluating the defects on a silicon wafer surface quantitatively by detecting the intensity distribution, “ laser scattered defect pattern ( LSDP )“, corresponding to the superposition of scattered light from a defect and reflected light from a surface. In order to verify a feasibility to detect “crystal originated particles ( COPs )” and t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering Research and Reports
سال: 2020
ISSN: 2582-2926
DOI: 10.9734/jerr/2020/v12i117071