Improving Surface Smoothness of Aluminium Alloys Multi-Bead Weld for Welding Rapid Forming Application
نویسندگان
چکیده
منابع مشابه
Numerical Modelling of Drawbeads for Forming of Aluminium Alloys
The drawbeads in stamping tools are usually designed based on experience from the forming of steel. However, aluminium alloys display different forming behaviour to steels, which is not reflected in the drawbead design for tools used for stamping aluminium. This paper presents experimental results from different semi-circular drawbead geometries commonly encountered in automotive dies and compa...
متن کاملLaser welding of dissimilar aluminium alloys with filler material
Laser welding of dissimilar aluminium alloys with filler material Luís Filipe Amaro Pinto Instituto Superior Técnico – Technical University of Lisbon – Portugal September 2008 Abstract The aluminium alloys are materials with great potential because of its high strength and low weight. However, the welding of dissimilar aluminium alloys is difficult in autogeneous welding, due to these alloys ar...
متن کاملExperimental simulation of surface pitting of degraded electrodes in resistance spot welding of aluminium alloys
A novel experimental technique, using specially designed electrodes (with machined annular and circular pits, and central cavities), was developed to simulate the effects of pitting morphology of the electrode tip face on weld nugget size and joint strength in resistance spot welding of aluminium alloys. Results of the experimental simulations indicate that the distribution of electrode contact...
متن کاملProblems in Welding of High Strength Aluminium Alloys
The 7XXX series alloys are heat-treatable Al-Zn-Mg or Al-Zn-Mg-Cu alloys. They develop their strength by solution heat treatment followed by ageing. In contrast to the 5XXX series alloys, the 7XXX series alloys do not respond favourably to cold work, because they are strengthened almost exclusively by GP zone formation and precipitates which nucleate from the GP zones. Introducing many new disl...
متن کاملOptimization of Weld Bead Width in Tungsten Inert Gas Welding of Austenitic Stainless Steel Alloy
This paper investigates the effects of process parameters on weld bead width of austenitic stainless steel SS-310 in tungsten inert gas welding. The four parameters namely welding current, type of gas, gas flow rate and included angle of weld plates during butt joint were varied at three levels. The DOE approach was used to design experimental conditions. Orthogonal array L9 was used for carryi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Mechanics and Materials
سال: 2015
ISSN: 1662-7482
DOI: 10.4028/www.scientific.net/amm.773-774.216