In Process Recognition of Cutting States
نویسندگان
چکیده
منابع مشابه
Wastewater Treatment of Stone Cutting Industries by Coagulation Process
Background & Aims of the Study: The wastewater created as a result of stone cutting industries enters some pools for re-consumption so that its suspended solids settle by gravity. By taking to account the high volume of water and sludge, treatment of wastewater and removal of sludge cause many problems for stone cutting units. The objective of this study was to determine the quality of wast...
متن کاملChaos in a Cutting Process
The dynamics of the cutting process are investigated. Using the increase of cutting depth as a control parameter, two diierent cutting regimes are observed. In the rst regime, which is observed at small cutting depths, complex, high-dimensional dynamics occur. In the second cutting regime, observed for deeper cuts, low dimensional dynamics are typical. The second cutting regime is usually ident...
متن کاملExperimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملOptimization of Cutting Parameters in Turning Process
Predicting the main cutting force during turning is of great importance as it helps in setting the appropriate cutting parameters before machining starts.Again, optimization of cutting parameters is one of the most important elements in any process planning of metal parts as economy of machining operation plays a key role in gaining competitive advantage. This paper presents an experimental stu...
متن کاملSimulation of Cutting Process in Turning
This paper presents simulation of cutting process by turning of polyamide PA 66, the simulation based on approach Arbitrary Lagrangian Eulerian, ALE. Was taken into account a tool knife CNMA from Coromant. The flow stress of the workpiece is modeled as function of strain, strain rate and temperature, so as to reflect its dynamic changes in physical properties. In this way, the influences of dep...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. C, Dynamics, control, robotics, design and manufacturing
سال: 1994
ISSN: 1340-8062
DOI: 10.1299/jsmec1993.37.638