Incremental Hole-Drilling Method <i>Vs.</i> Thin Components: A Simple Correction Approach
نویسندگان
چکیده
منابع مشابه
A simple model for laser drilling
A simple mathematical model of laser drilling is proposed. Assuming axi-symmetry of the process around the axis of the laser beam, a one-dimensional formulation is obtained after cross-sectional averaging. The novelty of the approach relies on the fact that even after dimension reduction, the shape of the hole can still be described. The model is derived, implemented and validated for drilling ...
متن کاملMicro-hole drilling with femtosecond fiber laser
In this paper, micro-hole drilling in ambient air is presented using fs fiber laser (750 fs & 1030 nm). Micro holes were fabricated in both transparent (glasses) and non-transparent materials (metals and tissues). Hole shape and morphology was characterized and evaluated with optical microscope and scanning electron microscopy (SEM). Debris-free micro holes with good roundness and no thermal da...
متن کاملDetermining optimum electro discharge machining parameters for drilling of a small hole by utilizing Taguchi method
Electro discharge machining (EDM) is a process that uses an electric sparks to generate the high temperature and melt the workpiece. One of the EDM process is drilling. In EDM drilling, an electro thermal mechanism is introduced between the electrode and work piece to create the hole. The hole size is dependent on the diameters of electrode used during the drilling process. The present study pe...
متن کاملA simple method for recording thin-layer acrylamide gel electropherograms.
Thin-layer acrylamide gel electrophoretic technique, based on the method described by Nandi and Lewis,' has been used in our laboratory for the electrophoresis of blood and malaria parasite enzymes. It was found that preservation of the enzyme electropherograms in acid solution is cumbersome, space-occupying, and unstable. Alternative methods for permanent recording of the electropherograms are...
متن کاملEffect of the Hole-bottom Fillet Radius on the Residual Stress Analysis by the Hole Drilling Method
The hole drilling method is based on the measuring of the surface relaxed strains when a small hole is drilled on the examined component. From the relaxed strains, measured generally by using special strain gage rosette, the residual stresses is computed by using proper influence coefficients, provided also by the ASTM E837-08 standard. Such influence coefficients are obtained by numerical simu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Materials Research
سال: 2014
ISSN: 1662-8985
DOI: 10.4028/www.scientific.net/amr.996.283