Indoor Massive MIMO Channel Modelling Using Ray-Launching Simulation
نویسندگان
چکیده
منابع مشابه
Intelligent Ray Launching Algorithm for Indoor Scenarios
This article describes the indoor IRLA (Intelligent Ray Launching Algorithm), which originates from an efficient outdoor propagation prediction model. Implementation and validation are given in detail. An indoor office scenario is selected and simulations via the IRLA model and two other reference models have been performed. Predictions are analyzed and recommendations are given. Results show t...
متن کاملThe Impact of Antenna Height on 3D-MIMO Channel: A Ray Launching Based Analysis
Three dimension (3D) Multi-input-multi-output (MIMO) scheme, which exploits another dimension of the spatial resource, is one of the enabling technologies for the next generation mobile communication. As the elevation angle in 3D-MIMO channel model might varies against the height of the base station transmit antenna, it has to be taken into account carefully. In this paper, the impact of antenn...
متن کاملMIMO Channel Modelling
Multiple antenna communications technologies offer significant advantages over single antenna systems. These advantages include extended range, improved reliability in fading environments and higher data throughputs. If multiple antennas are provided only at the transmitting end of a link then the system is referred to as multiple input single output (MISO). If multiple antennas are provided on...
متن کاملIndoor MIMO Channel Measurements Using Dual Polarized Patch Antennas
† Supported by the Alberta Informatics Circle of Research Excellence (iCORE), the Natural Sciences and Engineering Research Council (NSERC) of Canada, the Canadian Foundation for Innovation (CFI) and the National Sciences Foundation (NSF) under grant ECS9979323. Abstract – A mobile 4x4 multiple input multiple output (MIMO) system containing dual polarized patch antennas is used to perform wirel...
متن کاملBluetooth Indoor Channel Simulation
The Bluetooth radio multipath, fading indoor channel with Additive White Gaussian Noise (AWGN), was evaluated by simulation using a component-based architecture to model the Physical layer. The communication model included Forward Error Correction (FEC) and Automatic Repeat Request (ARQ) schemes. The observed Bit Error Rate (BER) versus Signal:Noise Ratio (SNR) using AWGN and a statistical chan...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Antennas and Propagation
سال: 2014
ISSN: 1687-5869,1687-5877
DOI: 10.1155/2014/279380