Inelastic Test and Design Method of Cold-formed Steel Lipped Channel Members in Bending
نویسندگان
چکیده
منابع مشابه
Comparative Study on Distortional Buckling Strength of Cold-Formed Steel Lipped Channel Sections
Usage of cold formed steel structural components for buildings and structures is gaining popularity in India for a decade. Hot rolled steel member behaviour and design are well developed, whereas the cold formed steel member behaviour and design is not developed fully compared to the rest of the world. The Indian code for cold-formed steel design, IS 801 was revised during 1975, which is in lin...
متن کاملLocal and Distortional Buckling of Cold-Formed Steel Members
Laminar structures have a high post-buckling strength reserve. Cold-formed steel profiles can be taken as a set of thin plate elements. Therefore it is necessary to design this type of profiles taking into account that reserve of strength in post-local buckling modes of failure. The method normally used to design this type of structures is based on the Effective Width concept. The Effective Wid...
متن کاملYield - line analysis of cold - formed steel members
The objective of this paper is to provide a state of the art review of the application of yield-line analysis to cold-formed steel members, and present a newly developed solution to the stresses that develop in an inclined yield-line. Yield-line analysis in cold-formed steel members is shown to be distinct from traditional yield-line applications. Challenges in the application of yield-line ana...
متن کاملOn Cold-Formed Steel Construction
Powder-actuated (also referred to as low velocity or powder-driven) fasteners are commonly used to attach cold-formed steel framing members, usually a track, to a concrete or structural steel support. Although commonly used, their behavior is less well understood than other fasteners such as screws, bolts and welds. The AISI Cold-Formed Steel Design Manual does not explicitly address powder act...
متن کاملFlexural -Torsional Buckling Tests of Cold-Formed Lipped Channel Beams Under Restrained Boundary Conditions
In this paper, tests on flexural buckling ( Lateral – Torsional ) of cold-formed steel(CFS) lipped Channel beams under restrained boundary conditions are described Two point loading for flexural tests have been established for 3.0m span to obtain uniform bending moment. The section sizes selected for testing are 100x50x10 mm, 100x50x15 mm and 100x50x20 mm with 1.6mm and 2.0mm thickness for the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Open Civil Engineering Journal
سال: 2016
ISSN: 1874-1495
DOI: 10.2174/1874149501610010625