Influence of cutting edge radius on process forces in orthogonal machining of carbon fibre reinforced plastics (CFRP)
نویسندگان
چکیده
منابع مشابه
Effect of chisel edge in ultrasonic assisted drilling of carbon fibre reinforced plastics (CFRP)
Ultrasonic assisted drilling (UAD) has been reported effective for thrust force reduction during drilling of CFRP resulting in lower exit delamination. However, this process is not fully understood in relation to machining theory. This work focused on understanding the separate effects of chisel and cutting edges during UAD in comparison with conventional drilling (CD). Experiments were perform...
متن کاملOptimization of Laser Cutting Parameters on the Laminated Carbon Fibre Reinforced Plastics (CFRP) Composites Using DOE Technique
Nowadays, carbon fiber reinforced plastics (CFRP) composites is widely used in the aerospace industry due to its excellent mechanical properties. In laser cutting process, high powers are used to cut materials then material melts and burns leaving edges with a high quality finish. To fulfill the high demand of cutting quality, a set of laser cutting parameters of CFRP material are studied. The ...
متن کاملJoining of Carbon Fibre Reinforced Plastics for Automotive Applications
The introduction of carbon-fibre reinforced plastics in load bearing automotive structures provides a great potential to reduce vehicle weight and fuel consumption. To enable the manufacture and assembly of composite structural parts, reliable and cost-effective joining technologies must be developed. This thesis addresses several aspects of joining and load introduction in carbon-fibre reinfor...
متن کاملSome observations in grinding unidirectional carbon fibre-reinforced plastics
This paper investigates the grinding performance of epoxy matrix composites reinforced by unidirectional carbon fibres, using an alumina grinding wheel. Emphasis was placed on understanding the effect of fibre orientations and grinding depths on the grinding force and surface integrity, and on understanding the grinding mechanisms, with a comparison to orthogonal cutting. It was found that grea...
متن کاملExperimental Study on Milling CFRP with Staggered PCD Cutter
Carbon fiber reinforced plastics (CFRP) have good physical properties, such as high specific strength and high specific modulus. However, cutting delamination, tearing and burr, etc. often occur in the machining process of CFRP, which results in the uncontrollability of machining surface quality and serious tool wear. In this paper, milling of CFRP with a staggered cutter was carried out, the c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2019
ISSN: 2212-8271
DOI: 10.1016/j.procir.2019.09.042