Influence of milling process on efavirenz solubility
نویسندگان
چکیده
منابع مشابه
Analysis of Milling Process Parameters and their Influence on Glass Fiber Reinforced Polymer Composites (RESEARCH NOTE)
Milling of fiber reinforced polymer composites is of great importance for integrated composites with other mating parts. Improper selection of cutting process parameters, excessive cutting forces and other machining conditions would result in rejection of components. Therefore, machining conditions are optimized to reduce the machining forces and damages. This work reports practical experiments...
متن کاملSolubility Study in Ag-Cu Binary System Prepared By Ball Milling Process
Solid solutions of Ag-Cu were prepared via ball milling process, for about 5-30 h. The Cu-20at%Ag and Cu-3.64at%Ag composition were investigated by X-ray diffraction technique. It was realized that the solid solubility level could be increased by increasing the initial solute content in the mixture. In addition, shifts in peak positions of silver and copper were observed with milling time. The ...
متن کاملthe influence of the neo-platonic concept of poetic imagination on wordsworth’s poetry
بر اساس نظریه افلاطون در باره شعر خلاقیت هنری مورد انتقاد قرار گرفته است. نظریه کلی در مورد شعر این بود که شعر از ظواهرتقلید میکند و نه حقیقت. چون سایه ای از حقیقت است. اما با پیدایش فلسفه نو افلاطونی، انتقاتات قبلی در مورد شعر و شاعری اصلاح شد. فلوطین در کتاب انئید، اساس خلق هنری را بر محور مُثل افلاطونی قرار داد. وی باور داشت که هنر مندان در خلق آثار هنری، تحت تاثیر مُثل افلاطونی بوده و عوالمی ...
Influence of Milling Media on Mechanically
Wet ball milling was used to exfoliate MoS2. The aim of the study was to examine how the surface energy of all the individual materials affected the formation of the nano‐ sheets. Two types of milling balls were selected: one made of steel and one made of Al2O3. The liquids used were water (H2O), isopropyl alcohol (C3H8O) and kerosene. The obtained nanosheets were identified and characterized u...
متن کاملInfluence of Process Parameters on Residual Stresses Induced by Milling of Aluminum Alloy Using Taguchi’s Techniques
In this paper, the straight flute end-milling cutter used for machining of Al-Si-Mg-Fe alloy work pieces was investigated. The machining processes could induce residual stresses that enhance greatly the performance of the machined component. Machining residual stresses correlate very closely with the cutting parameters. In the experiments, the residual stress on the surface of workpiece was mea...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Pharmacy And Bioallied Sciences
سال: 2017
ISSN: 0975-7406
DOI: 10.4103/0975-7406.206218