INFLUENCE OF SELECTED TECHNOLOGICAL PARAMETERS ON CUTTING SURFACE ROUGHNESS IN MATERIAL LASER CUTTING

Effects of the Cutting Fluid Types and Cutting Parameters on Surface Roughness and Thrust Force

In this study, three different vegetable-based cutting fluids developed from raw and refined sunflower oil and two commercial types (vegetable and mineral based cutting oils), were carried out to determine for thrust force and surface roughness during drilling of AISI 304 austenitic stainless steel with HSSE tool. The uses of vegetable cutting oils was investigated in reducing thrust force and ...

LASER CUTTING PARAMETERS The laser cutting parameters are dependent on the beam characteristics, the cutting rate

The laser cutting parameters are dependent on the beam characteristics, the cutting rate required, the composition and thickness of the material to be cut, and the desired cut edge quality. The laser cutting process and cut quality depend upon the proper selection of laser and workpiece parameters. Deficiencies in cutting quality may be related to the slow process drifts and disturbances that a...

Influence of Process Parameters on Surface Roughness in Abrasive Waterjet Cutting of Titanium

Abrasive waterjet cutting is one of the nontraditional machining processes capable of cutting wide range of hard-to-cut materials. This process incurs relatively higher initial investment, maintenance and operating costs. Therefore optimum choice of the process parameters is essential for the economic, efficient and effective utilization of this process. This paper assesses the influence of pro...

Optimization of Cutting Parameters for Surface Roughness in Turning

The optimized cutting parameters are very important to control the required surface quality. In the present study, Taguchi method is used to find the optimal cutting parameters for surface roughness (Ra) in turning. The L-18 orthogonal array, the signal-to-noise ratio & analysis of variance are employed to study the performance characteristics in turning operations of AISI-410 steel bars using ...

Multi Objective Optimization of Cutting Parameters in Turning Operation to Reduce Surface Roughness and Cutting Forces