Influence of tool geometry and numerical parameters when modeling orthogonal cutting of LFRP composites
نویسندگان
چکیده
منابع مشابه
The Influence of Johnson-Cook Parameters on SPH Modeling of Orthogonal Cutting of AISI 316L
Over the past few decades, there has been a growing interest in modelling of machining processes. In this regard, smoothed particle hydrodynamics (SPH) is one of the latest methods used for that purpose. SPH is a powerful technique that can be used in handling problems of large deformation that are difficult to be tackled using traditional finite element methods. The current work aims to presen...
متن کاملInfluence of the Tool Edge Geometry on Specific Cutting Energy at High- Speed Cutting
This paper presents specific cutting energy measurements as a function of the cutting speed and tool cutting edge geometry. The experimental work was carried out on a vertical CNC machining center with 7,500 rpm spindle rotation and 7.5 kW power. Hardened steels ASTM H13 (50 HRC) were machined at conventional cutting speed and high-speed cutting (HSC). TiN coated carbides with seven different g...
متن کاملModeling of heat generations for different tool profiles in friction stir welding: study of tool geometry and contact conditions
In this work, improved heat generation models are developed for straight and tapered shoulder geometries with different tool pin profiles in friction stir welding. The models are developed considering the welding process as a combination of the pure sliding and the pure sticking conditions. From the results, the amount of heat generation is directly proportional to the number of edges in the pi...
متن کاملEffect of cutting parameters on tool-chip interface temperature in an orthogonal turning process
The aim of this paper is to investigate the effect of cutting speed and uncut chip thickness on cutting performance. A Finite Element Method (FEM) based on the ABAQUS explicit software which involves Johnson-Cook material mode and Coulombs friction law was used to simulate of High Speed Machining (HSM) of AISI 1045 steel. In this simulation work, feed rate ranging from 0.05 mm/rev to 0.13 mm/re...
متن کاملnumerical simulation of orthogonal cutting process and determination of built up layer thickness
the built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. the built up layer (bul) is formed in second deformation zone near the tool-chip interface in the back of the chip. this parameter influences the tool life and machined surface quality. this bul should not be confused with the built up edge (bue). the deformation of the bul in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Composites Part A: Applied Science and Manufacturing
سال: 2011
ISSN: 1359-835X
DOI: 10.1016/j.compositesa.2011.04.023