Initial Distribution of Average Excess Pore Water Pressure Due to a Trapezoidal Load
نویسندگان
چکیده
منابع مشابه
Pore Pressure and Viscous Shear Stress Distribution Due to Water Flow within Asphalt Pore Structure
There has been a concentrated effort in modeling fluid flow in asphalt pavements, and most of the existing work has been limited to evaluation of directional permeabilities. The effects of other phenomena, such as development of flow-induced pore pressure and viscous shear stress distributions at the pore–solid interfaces, on moisture damage in an asphalt pore structure have not been fully unde...
متن کاملPrediction of excess pore pressure due to dissociation of gas hydrate within sandy soils
The small hydrate concept (SHC) was proposed to predict the generated excess pore water pressure due to dissociation of gas hydrate within sandy soils. This concept was then used to calculate excess pore water pressure in the Storegga slide of which gas hydrate dissociation may have contributed. Since the excess pore water pressure calculated by the SHC resulted in the considerable loss of stif...
متن کاملExperimental Results of Pressure Fluctuations in a Water Conduit Section Due to Formation of Unstable Two-Phase Air-Water Flow
The study of two-phase fluid flow behavior in hydraulic structures such as pressurized flow tunnels, culverts, sewer pipes, junctions and other similar conduits is of great importance. A two-phase mixture flowing in a pipe can exhibit several interfacial geometries such as bubbles, slugs or films, depending on the fluid and hydrodynamic properties of flow. The main variables, giving rise to a v...
متن کاملExperimental Results of Pressure Fluctuations in a Water Conduit Section Due to Formation of Unstable Two-Phase Air-Water Flow
The study of two-phase fluid flow behavior in hydraulic structures such as pressurized flow tunnels, culverts, sewer pipes, junctions and other similar conduits is of great importance. A two-phase mixture flowing in a pipe can exhibit several interfacial geometries such as bubbles, slugs or films, depending on the fluid and hydrodynamic properties of flow. The main variables, giving rise to a v...
متن کاملA Least Squares Approach to Estimating the Average Reservoir Pressure
Least squares method (LSM) is an accurate and rapid method for solving some analytical and numerical problems. This method can be used to estimate the average reservoir pressure in well test analysis. In fact, it may be employed to estimate parameters such as permeability (k) and pore volume (Vp). Regarding this point, buildup, drawdown, late transient test data, modified Muskat method, interfe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Soils and Foundations
سال: 1974
ISSN: 0038-0806
DOI: 10.3208/sandf1972.14.3_67