منابع مشابه
Initiation of cracks in dental amalgam.
The force required to initiate cracks in dental amalgam beams was measured and related to the microstructure. The force measured was dependent on age and on the distribution of phases on the tension side of the beam. The Ag-Cu phase is most resistant to failure in Dispersalloy and an experimental alloy.
متن کاملWear of dental amalgam.
The wear of cental amalgam was studied by single- and double-pass sliding and by a silicon carbide abrasion test. A dispersed amalgam showed significantly better resistance to two-body abrasion than the spherical amalgams tested. The wear amalgam was determined by resistance to penetration and by a ductile mode of surface failure over the load range studied. Differences in the wear of amalgam a...
متن کاملMicrostructure of dental amalgam.
Numerous studies have been done in the past to identify the phases present in dental amalgam. Both metallographic and X-ray diffraction techniques have been used.-' Most researchers now presume that dental amalgam consists mainly of three phases. The original particle is an alloy of Ag, Sn, Cu, and sometimes Zn; the major portion is the compound Ag3Sn, which is often referred to as Py. After am...
متن کاملDental amalgam--environmental aspects.
Increasing knowledge about the risk of toxic effects caused by anthropogenic mercury accumulation in ecosystems has resulted in a growing pressure for reduction of the discharge of mercury waste. Consequently, the mercury waste problems of dental clinics have been given increased attention, and restrictions on handling and discharge of contaminated waste have been established in several countri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Dental Research
سال: 1975
ISSN: 0022-0345,1544-0591
DOI: 10.1177/00220345750540060601