Inspection Path planning of Free Form Surfaces Using Virtual Machining
نویسندگان
چکیده
منابع مشابه
Tool Path Planning for Machining Free-form Surfaces
This paper is about new iso-parametric tool path planning for machining trimmed freeform surfaces. The trimmed surface has been re-parameterized by two different parameterization techniques, namely, the partial differential equation method and the newly developed boundary interpolation method. The efficiency of the scheme has been measured in terms of path length and computational time needed f...
متن کاملMachining Free-Form Surfaces
This paper presents an analytical method for planning an efficient tool-path in machining free-form surfaces on 3-axis milling machines. This new approach uses a nonconstant offset of the previous tool-path, which guarantees the cutter moving in an unmachined area of the part surface and without redundant machining. The method comprises three steps: (1) the calculation of the tool-path interval...
متن کاملError Analysis of Machining Accuracy of Free-form Surfaces Using On-line Inspection Method
In this paper error sources existing in the on-line inspection system for numerical control machines are analyzed. A mathematical model of the geometric errors of a three-axis machining center is created and the pretravel variations are obtained in different directions. Then an error compensation is applied to improve the accuracy of the on-line inspection system. A methodology of spatial stati...
متن کاملIso-level tool path planning for free-form surfaces
The aim of tool path planning is to maximize the efficiency against some given precision criteria. In practice, scallop height should be kept constant to avoid unnecessary cutting, while the tool path should be smooth enough to maintain a high feed rate. However, iso-scallop and smoothness often conflict with each other. Existing methods smooth iso-scallop paths one-by-one, which make the final...
متن کاملTool orientation planning for five-axis CNC machining of open free-form surfaces
For the geometry characteristics of open free-form surfaces, it is hard to consider global interference during the planning of feasible domains. Therefore, the optimal kinematic orientation of tool axis will no longer be confined to the boundary of feasible domains. In this paper, according to the principle demanding that the tool should be fitted to a surface as close as possible and relevant ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Manufacturing
سال: 2018
ISSN: 2351-9789
DOI: 10.1016/j.promfg.2018.07.091