Integral-based constitutive equation for rubber at high strain rates
نویسندگان
چکیده
منابع مشابه
A Micromechanics Based Constitutive Model for Brittle Failure at High Strain Rates
The micromechanical damage mechanics formulated by Ashby and Sammis, 1990, “The Damage Mechanics of Brittle Solids in Compression,” Pure Appl. Geophys., 133(3), pp. 489–521, and generalized by Deshpande and Evans 2008, “Inelastic Deformation and Energy Dissipation in Ceramics: A Mechanism-Based Constitutive Model,” J. Mech. Phys. Solids, 56(10), pp. 3077–3100. has been extended to allow for a m...
متن کاملA constitutive model for ballistic gelatin at surgical strain rates.
This paper describes a constitutive model for ballistic gelatin at the low strain rates experienced, for example, by soft tissues during surgery. While this material is most commonly associated with high speed projectile penetration and impact investigations, it has also been used extensively as a soft tissue simulant in validation studies for surgical technologies (e.g. surgical simulation and...
متن کاملDynamic mechanical response and a constitutive model of Fe-based high temperature alloy at high temperatures and strain rates
The effects of strain rate and temperature on the dynamic behavior of Fe-based high temperature alloy was studied. The strain rates were 0.001-12,000 s(-1), at temperatures ranging from room temperature to 800 °C. A phenomenological constitutive model (Power-Law constitutive model) was proposed considering adiabatic temperature rise and accurate material thermal physical properties. During whic...
متن کاملPREDICTION OF HOT DEFORMATION BEHAVIOUR OF A PH STAINLESS STEEL AT HIGH STRAIN RATES
In this study the hot deformation behaviour of a precipitation hardened (PH) stainless steel at high strain rates has been predicted through hot compression testing. Stress-strain curves were obtained for a range of strain rates from 10-3 to 10+1 S-1 and temperatures from 850 to 1150°C. Results obtained by microstructure and stress-strain curves show that at low temperatures and high strain rat...
متن کاملThe uniaxial stress versus strain response of pig skin and silicone rubber at low and high strain rates
The uniaxial compressive responses of silicone rubber (B452 and Sil8800) and pig skin have been measured over a wide range of strain rates (0.004–4000 s ). The uniaxial tensile response of the silicone rubbers was also measured at low strain rates. The high strain rate compression tests were performed using a split-Hopkinson pressure bar made from AZM magnesium alloy. High gain semi-conductor s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Solids and Structures
سال: 2007
ISSN: 0020-7683
DOI: 10.1016/j.ijsolstr.2007.02.038