Integration of Heteromaterial Microelements into Plastic Microfluidic Devices by Capillary-force-assisted Micromolding
نویسندگان
چکیده
منابع مشابه
Micromolding of solvent resistant microfluidic devices.
We demonstrate a rapid fabrication procedure for solvent-resistant microfluidic devices based on the perfluoropolyether (PFPE) SIFEL. We carefully modified the poly-dimethylsiloxane (PDMS) micromolding procedure, such that it can still be executed using the standard facilities for PDMS devices. Most importantly, devices with a thin SIFEL layer for the patterned channels and a PDMS support layer...
متن کاملLarge-Area Patterning by Vacuum-Assisted Micromolding
946 Ó WILEY-VCH Verlag GmbH, D-69469 Weinheim, 1999 0935-9648/99/1108-0946 $ 17.50+.50/0 Adv. Mater. 1999, 11, No. 11 layers we achieved were very compact films, i.e. the grains were densely arranged with a large number of inter-grain contacts. Moreover, the electrical measurements showed that Nb addition only had a negligible influence on the intergrain barrier. For these two reasons, magnific...
متن کاملMicrofab-less Microfluidic Capillary Electrophoresis Devices.
Compared to conventional bench-top instruments, microfluidic devices possess advantageous characteristics including great portability potential, reduced analysis time (minutes), and relatively inexpensive production, putting them on the forefront of modern analytical chemistry. Fabrication of these devices, however, often involves polymeric materials with less-than-ideal surface properties, spe...
متن کاملTip-multi-breaking in Capillary Microfluidic Devices
We report tip-multi-breaking (TMB) mode of droplet breakup in capillary microfluidic devices. This new mode appears in a region embraced by Cai = 0 and lg(Cai) = -8.371(Ca0) -7.36 with Ca0 varying from 0.35 to 0.63 on the Cai - Ca0 phase diagram, Cai and Ca0 being the capillary numbers of inner and outer fluids, respectively. The mode is featured with a periodic, constant-speed thinning of the ...
متن کاملPatterning polymer light-emitting diodes by micromolding in capillary
Here we describe a method of patterning electroluminescent (EL) polymers using micromolding in capillary (MIMIC). MIMIC is the one of the lithographic methods based on the microfludics among the soft lithography using a patterned poly(dimethylsiloxane) (PDMS) elastomer. The patterned microstructures of poly(dioctylfluorene) (PDOF), poly(p-phenylenevinylene) (PPV), and poly(2methoxy-5-2 0-ethylh...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Photopolymer Science and Technology
سال: 2014
ISSN: 0914-9244,1349-6336
DOI: 10.2494/photopolymer.27.471