Intensification of heat transfer between heat exchange surfaces at low RE values
نویسندگان
چکیده
منابع مشابه
Heat Transfer from Finned Surfaces
conv hAs (Ts T ) where As is the heat transfer surface area and h is the convection heat transfer coefficient. When the temperatures Ts and T are fixed by design considerations, as is often the case, there are two ways to increase the rate of heat transfer: to increase the convection heat transfer coefficient h or to increase the surface area As. Increasing h may require the installation of a p...
متن کاملMass and Heat Transfer at Different Heat Exchange Surfaces and Their Suitability for Use in Thermal Desalination Plants
Abstract: A new concept for small scale multi-stage distillation (MSD) desalination plants is presented allowing an installation in remote rural areal due to low maintenance, operating and investment costs. It is based on extensive studies on heat and mass transfer using 6 different condensation / heat transfer surfaces or material combinations. Basically all 6 condensation surfaces except glas...
متن کاملNear-field radiative heat transfer between macroscopic planar surfaces.
Near-field radiation allows heat to propagate across a small vacuum gap at rates several orders of magnitude above that of far-field, blackbody radiation. Although heat transfer via near-field effects has been discussed for many years, experimental verification of this theory has been very limited. We have measured the heat transfer between two macroscopic sapphire plates, finding an increase i...
متن کاملCondensation Heat Transfer on Nanoengineered Surfaces
This thesis presents a series of three related studies with the aim of developing a surface that promotes robust dropwise condensation. Due to their remarkably low droplet adhesion, superhydrophobic surfaces were investigated for application to dropwise condensation. Although precise model superhydrophobic surfaces were necessary to gain insight into these phenomena, it was recognized that wide...
متن کاملBiofilm Formation on Polymeric Heat Transfer Surfaces
The biofouling affinity on different polymeric surfaces (PP, PSU, PET, PEEK) in comparison with SS 1.4301 was studied using the model bacterium E.coli K12 DSM 498. A test rig with seven identical chambers allowed investigations at different system conditions (throughputs, inclination of the heat transfer cell, etc.). The biofilm mass deposited on the polymer surfaces was several magnitudes smal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chemical and Process Engineering
سال: 2015
ISSN: 2300-1925
DOI: 10.1515/cpe-2015-0023