Interfacial Reactions at Early Stages of Mn Addition to Liquid Fe
نویسندگان
چکیده
منابع مشابه
Early stages of soldering reactions
An experiment on the early stages of intermetallic compound layer growth during soldering and its theoretical analysis were conducted with the intent to study the controlling factors of the process. An experimental technique based on fast dipping and pulling of a copper coupon in liquid solder followed by optical microscopy allowed the authors to study the temporal behavior of the sample on a s...
متن کاملGrowth and Magnetic Oscillatory Exchange Coupling of Mn/Fe(001) and Fe/Mn/Fe(001)
The magnetic ordering and the interlayer exchange coupling in Mn and Fe/Mn wedge structures grown epitaxially on Fe(001) whisker substrates were investigated using scanning electron microscopy with polarization analysis (SEMPA). In bare Mn/Fe(001) samples, the magnetization of the top Mn layer is collinear with the Fe magnetization, and oscillates between ferromagnetic and antiferromagnetic ali...
متن کاملViscosity of liquid Fe at high pressure
Synchrotron x-ray radiography has been used to measure the viscosity of pure liquid Fe at high pressure and temperature in a large volume press. A probe sphere rising through liquid Fe at high pressure and temperature is imaged, in situ, allowing for the derivation of sample viscosity through a modified form of Stokes’ equation. The effect of pressure on viscosity is fit by the semi empirical f...
متن کاملAcquisition of Mn(II) in addition to Fe(II) is required for full virulence of Salmonella enterica serovar Typhimurium.
The roles of the genes feoB (ABC ferrous iron transporter), mntH (proton-dependent manganese transporter), and sitABCD (putative ABC iron and/or manganese transporter) in Salmonella pathogenicity were investigated by using mutant strains deficient in one, two, or three transporters. Our results indicated that sitABCD encodes an important transporter of Mn(II) and Fe(II) which is required for fu...
متن کاملCatalytic oxidation of toluene over LaBO3 (B= Fe, Mn and Co) and LaCo0.7B′0.3O3 (B′= Fe and Mn) perovskite-type
In this paper, LaBO3 perovskite type catalyst formulations were prepared by sol-gel auto combustion method using citric acid as the fuel. Activity of catalysts was tested in catalytic oxidation of toluene as a model of volatile organic compounds. LaCoO3 perovskite formulation showed the highest activity among LaBO3 (Fe, Mn and Co) perovskite catalysts. So, LaCoO3 perovskite based catalyst was s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2014
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.54.1209