Interpretation Using Explicitly Encoded Phase, Amplitude and Fault Data
نویسندگان
چکیده
منابع مشابه
Analog Circuit Fault Detection Using Relative Amplitude and Relative Phase Analysis
A new method for detection of parametric faults occurring in analog circuits based on relative amplitude and relative phase analysis of the Circuit Under Test (CUT) is proposed. The relative amplitude is the common power change of the signals and the relative phase presents the relative phase offset of the signals. In the proposed method, the value of each component of the CUT is varied within ...
متن کاملmodeling loss data by phase-type distribution
بیمه گران همیشه بابت خسارات بیمه نامه های تحت پوشش خود نگران بوده و روش هایی را جستجو می کنند که بتوانند داده های خسارات گذشته را با هدف اتخاذ یک تصمیم بهینه مدل بندی نمایند. در این پژوهش توزیع های فیزتایپ در مدل بندی داده های خسارات معرفی شده که شامل استنباط آماری مربوطه و استفاده از الگوریتم em در برآورد پارامترهای توزیع است. در پایان امکان استفاده از این توزیع در مدل بندی داده های گروه بندی ...
Amplitude and Phase Modulation Using QAM Receivers
Simulations have investigated single laser 100G Ethernet links enabled by CAP-16 using QAM receivers that not only lower significantly system timing jitter sensitivity but also outperform PAM and standard CAP in terms of power margin. OCIS codes: (060.2330) Fiber optics communications; (060.4080) Modulation.
متن کاملNear-field amplitude and phase recovery using phase-shifting interferometry.
Scattering-type scanning near-field optical microscopy has allowed for investigation of light-matter interaction of a large variety of samples with excellent spatial resolution. Light incident on a metallic probe experiences an amplitude and phase change on scattering, which is dependent on optical sample properties. We implement phase-shifting interferometry to extract amplitude and phase info...
متن کاملFault Diagnosis and Fault-Tolerant SVPWM Technique of Six-phase Converter under Open-Switch Fault
In this paper, a new open-switch fault diagnosis method is proposed for the six-phase AC-DC converter based on the difference between the phase current and the corresponding reference using an adaptive threshold. The open-switch faults are detected without any additional equipment and complicated calculations, since the proposed fault detection method is integrated with the controller required ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ASEG Extended Abstracts
سال: 2018
ISSN: 2202-0586
DOI: 10.1071/aseg2018abp076