INTRA-RING COMPRESSION STRENGTH OF LOW DENSITY HARDWOODS
نویسندگان
چکیده
منابع مشابه
Intra-ring Compression Strength of Low Density Hardwoods
Engineered wood composites are being crafted with increasingly smaller and smaller components, yet a search of the literature indicates a lack of intra-ring mechanical property data for almost all commercial wood types, particularly the underutilized low density hardwoods. In addition, there is no universally accepted testing regime for determining micromechanical properties of wood samples. As...
متن کاملMedium Density Fiberboard from Mixed Southern Hardwoods
Medium-density fiberboards of acceptable quality were made from a mixture of barky chips from 14 southern hardwoods. Boards made from fiber refined at three different plate clearances did not vary significantly in bending, internal bond (IB), or linear expansion. But, lack of replications and the fact that the refiner was not loaded to capacity caused these results to be inconclusive. Increasin...
متن کاملTensile Strength Properties of Tropical Hardwoods in Structural Size Testing
In Malaysia, there is no research done on the tensile strength of structural size timber. The tension stress found in the Malaysian code of practice, MS 544: Part 2: 2001, was not determined directly and it was taken as 60% of the bending strength values of small clear specimens. This paper presents the results of the tensile test on structural size timber specimens from selected Malaysian Trop...
متن کاملNoiseless Data Compression with Low-Density Parity-Check Codes
This paper presents a new approach to universal noiseless compression based on error correcting codes. The scheme is based on the concatenation of the Burrows-Wheeler block sorting transform (BWT) with the syndrome former of a Low-Density Parity-Check (LDPC) code. The proposed scheme has linear encoding and decoding times and uses a new closed-loop iterative doping algorithm that works in conju...
متن کاملBone mineral density and donor age are not predictive of femoral ring allograft bone mechanical strength.
While metal or plastic interbody spinal fusion devices are manufactured to appropriate mechanical standards, mechanical properties of commercially prepared structural allograft bone remain relatively unassessed. Robust models predicting compressive load to failure of structural allograft bone based on easily measured variables would be useful. Three hundred twenty seven femoral rings from 34 ca...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Maderas. Ciencia y tecnología
سال: 2006
ISSN: 0718-221X
DOI: 10.4067/s0718-221x2006000200005