Investigate the Fluctuation Size in Thrust Force and Chip Morphology in Drilling
نویسندگان
چکیده
منابع مشابه
vibration drilling tool and thrust force investigation in vibratory drilling process of al 2024-t6
vibratory drilling (vd)process is a new modern technology where longitudinal wave with high frequency (more than 16 khz) and low amplitude (usually between 2 up to 30 µm) is superimposed on the movement of cutting tool, resulting in connection and disconnection of cutting tool engagement with workpiece. in this study, in order to perform vibratory drilling process, two vibration tools are desig...
متن کاملThe Effect of Artificial Aging Treatment and Lubrication Modes on the Cutting Force and the Chip Surface Morphology when Drilling Al-Si-Mg (A356) Cast Alloys
This article reports the effects of various artificial aging methods and lubrication modes (dry, mist, wet) on the recorded cutting forces and chip morphology in drilling Al-Si-Mg (A356) cast alloys. In the course of this work, the work part sampled were as-received alloy (T0), solution heat-treated alloy (SHT) and then aged alloys at 155°C, 180°C, and 220°C (T4, T6, T61, T7), respectively. The...
متن کاملthe translators agency and ideological manipulation in translation: the case of political texts in translation classes in iran
در این تحقیق به نقش واسطه ای مترجم در ایجاد تغییرات ایدئولوژیک در ترجمه متون سیاسی پرداخته شده است. بدین منظور محقق متنی سیاسی در خصوص ادعاهای آمریکا در مورد برنامه هسته ای ایران را انتخاب کرد. این متن از سایت spacewar.com انتخاب شد که دارای ایدئولوژی مغرضانه در مورد برنامه هسته ای ایران است. سپس یک گروه 30 نفره از دانشجویان کارشناسی ارشدرشته مترجمی زبان انگلیسی دانشگاه شیخ بهایی انتخاب شدند. ا...
15 صفحه اولthe u.s. policy in central asia and its impact on the colored revolutions in the region (the case study of tulip revolution in kyrgyzstan)
چکیده ندارد.
15 صفحه اولModelling of Tool Life, Torque and Thrust Force in Drilling: a Neuro-fuzzy Approach
This paper presents the application of neuro-fuzzy approach for modelling tool life, torque and thrust force in drilling operation for set of given process parameters, namely cutting speed, feed rate and drill diameter. The proposed approach uses a hybrid-learning algorithm i.e., combination of the back-propagation gradient descent method and least squares method, to identify premise and conseq...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Celal Bayar Üniversitesi Fen Bilimleri Dergisi
سال: 2018
ISSN: 1305-130X
DOI: 10.18466/cbayarfbe.409399