Investigation of a combined gas-steam system with flue gas recirculation
نویسندگان
چکیده
منابع مشابه
Exhaust Gas Recirculation in On·board Diagnostic System
Introduce electronic control exhaust gas recirculation EGR system in the passenger cars and light duty vehicles was made because of fuel direct injectionengines. In this engines temperature combustion process is a higher then other type engine and in this connections NO, emissions were higher to. Simultaneously was appearing problems to electronic exhaust gas recirculation control in connection...
متن کاملEffects of Flue Gas Internal Recirculation on NOx and SOx Emissions in a Co-Firing Boiler
Volumetric combustion has been developed to realize a high substitution ratio of biomass in co-firing boilers, which features an intensive flue gas internal recirculation inside furnace. However, the characteristics of NOx and SOx emissions in large-scale boilers with volumetric combustion were not fully clear. In this paper, an Aspen Plus model of volumetric combustion system was built up base...
متن کاملSelective Exhaust Gas Recirculation in Combined Cycle Gas Turbine Power Plants with Post-combustion Carbon Capture
.................................................................................................................................... ii Acknowledgements .................................................................................................................. iii Declaration of originality .....................................................................................................
متن کاملFlue Gas Conditioning
Flue gas conditioning (FGC) systems offer an effective option for control of Particulate Matter (PM) emissions and enhances the performance of the Electrostatic Precipitators (EPs) when using coal of different properties. The increasing environmental awareness and the mandate of the Environmental Protection Agencies (EPA) in various countries to thermal power stations using coal-fired boilers f...
متن کاملFlue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chemical and Process Engineering
سال: 2016
ISSN: 2300-1925
DOI: 10.1515/cpe-2016-0025