Investigation of dynamic elastic deformation of parts processed by fused deposition modeling additive manufacturing
نویسندگان
چکیده
منابع مشابه
Additive Manufacturing of Cfrp Composites Using Fused Deposition Modeling: Effects of Carbon Fiber Content and Length
Additive manufacturing (AM) technologies have been successfully applied in various applications. Fused deposition modeling (FDM), one of popular AM techniques, is most widely used method for manufacturing of plastic materials. Due to the poor strength properties of pure plastic materials, there is a critical need to improve mechanical properties for FDMfabricated pure plastic parts. One of the ...
متن کاملinvestigation of effective parameters on the rigidity of light composite diaphragms (psscb) by fem
در این رساله با معرفی سقف های psscb متشکل از ترکیب ورق های فولادی ذوزنقه ای و تخته های سیمانی الیافی به عنوان سقف های پیش ساخته (سازگار با سیستم سازه ای قاب های فولادی سبک) به بررسی پارامترهای موثر بر صلبیت سقف، پرداخته می شود. در تحقیق حاضر ابتدا به مدل سازی دو نمونه سقف آزمایش شده، به روش اجزاء محدود با استفاده از نرم افزار تحلیلی abaqus ver 6.10 پرداخته شده است. نمونه های ساخته شده تحت اعما...
Dynamic Mechanical Properties of ABS Material Processed by Fused Deposition Modelling
This paper presents a study of dynamic mechanical properties of Fused Deposition Modelling (FDM) rapid prototyping processed material Acrylonitrile butadiene styrene (ABS). It involves the measurement of modulus and damping properties of the material as it is deformed under periodic stress. In this study, frequency sweep is performed in DMA 2980 equipment to determine modulus, damping and visco...
متن کاملMethods to Improve Surface Finish of Parts Produced by Fused Deposition Modeling
Fused deposition modeling (FDM) is one of the rapid prototyping technologies that can use plastic material, which can be effectively used for making patterns for investment casting. The surface finish of the investment casting depends upon the surface finish of the pattern. But the surface finish of the parts produced by using FDM is not very good as compared to wax patterns, which are conventi...
متن کاملAdditive Manufacturing: Reproducibility of Metallic Parts
The present study deals with the properties of five different metals/alloys (Al-12Si, Cu-10Sn and 316L—face centered cubic structure, CoCrMo and commercially pure Ti (CP-Ti)—hexagonal closed packed structure) fabricated by selective laser melting. The room temperature tensile properties of Al-12Si samples show good consistency in results within the experimental errors. Similar reproducible resu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Production Engineering & Management
سال: 2016
ISSN: 1854-6250,1855-6531
DOI: 10.14743/apem2016.3.223