Investigation on mechanical and Microstructural characteristics of Zn alloy MMC for bearing application
نویسندگان
چکیده
منابع مشابه
application of upfc based on svpwm for power quality improvement
در سالهای اخیر،اختلالات کیفیت توان مهمترین موضوع می باشد که محققان زیادی را برای پیدا کردن راه حلی برای حل آن علاقه مند ساخته است.امروزه کیفیت توان در سیستم قدرت برای مراکز صنعتی،تجاری وکاربردهای بیمارستانی مسئله مهمی می باشد.مشکل ولتاژمثل شرایط افت ولتاژواضافه جریان ناشی از اتصال کوتاه مدار یا وقوع خطا در سیستم بیشتر مورد توجه می باشد. برای مطالعه افت ولتاژ واضافه جریان،محققان زیادی کار کرده ...
15 صفحه اولEffect of Mechanical Alloying and Sintering on Phase Transformation, Microstructural Evolution, Mechanical Properties and Density of Zr-Cr Alloy
The purpose of present research was production ofZr-based alloy as the nuclear fuel cladding by mechanical alloying (MA) and sintering process. Firstly, Zr and Cr powders were mechanically alloyed to produce the refractory and hard Zr-10 wt% Cr alloy, and then, the powder mixtures were consolidated by press and following sintering at temperature of 800˚C min. The phase evolution, microstructura...
متن کاملMICROSTRUCTURAL AND MECHANICAL CHARACTERISTICS OF AlSiMnFe ALLOY PROCESSED BY EQUAL CHANNEL ANGULAR PRESSING
V.A. Andreyachshenko, Faculty of Nanotechnology and Metallurgy, Karaganda state technical University, Karaganda, Kazakhstan A.B. Naizabekov, Mining and Metallurgy Faculty, Rudny Industrial Institute, Rudny, Kazakhstan In the present research, equal channel angular pressing (ECAP) was conducted. The defectness degree of the alloy for one pass and maximum strain was determined. Ultra fine grained...
متن کاملeffect of postharvest application of chitosan and calcium chloride on decay and quality attributes of sweet cherry
چکیده ندارد.
15 صفحه اولThe effect of electron beam welding parameters on the microstructural characteristics and mechanical properties of dissimilar joint between 17-4PH steel and Ti6Al4V alloy
This study aimed to investigate the effect of electron beam welding parameters on the microstructural characteristics and mechanical properties of the dissimilar joint between 17-4PH precipitation hardening stainless steel and Ti6Al4V alloy. For this purpose, the welding of these two alloys was done without an interlayer and with an interlayer of copper with a thickness of 0.8 mm. Two different...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Today: Proceedings
سال: 2021
ISSN: 2214-7853
DOI: 10.1016/j.matpr.2021.05.058